Contact Platform Support
Help CenterShaft Diameter φ20mm Optical Shaft Clamping Pliers, Domestic Numax Spool Clamp, Pneumatic Normally Closed Type Mkrs2000a
Related Products
-
Shaft Diameter φ32mm Spool Clamp, Domestic Numax Optical Shaft Clamping Pliers, Pneumatic Normally Closed Type Mkrs3200aUS$ 240 - 246.15MOQ: 1 Piece -
Domestic Numax Kurangba for Optical Shafts, Pneumatic Normally-closed Air-cutoff Clamping Device Mkrs4000a, Optical Shaft ClampUS$ 352.31MOQ: 1 Piece
-
German Zimmer Clamping Pliers for Optical Shafts, Pneumatic Normally Closed Type Air-off Control Locking Device Mkrs6000a, Spool BrakeUS$ 625.38MOQ: 1 Piece
-
Numax Clamp, Pneumatic Brake Mkr4000a for Linear Shaft With Shaft Diameter φ40, Optical Shaft Clamping UnitUS$ 332.31 - 352.31MOQ: 1 Piece
-
Domestically Produced In-stock Linear Guide Gripper, Numax Pneumatic Normally Open Optical Axis Brake Mkr5000a, Locking Device for SpoolsUS$ 446.15MOQ: 1 Piece
Shaft diameter φ20mm optical axis clamping pliers, domestic NUMAX spool clamp, pneumatic normally closed type MKRS2000A. Product features:
For linear axes.
Used for fixing slides, positioning, and preventing vibration.
It is a normally closed (Normally Closed) type.
When air pressure is supplied: The clamping is released.
When air pressure is discharged: The shaft is clamped by the force of the spring.Products with opening pressures of 0.3MPa and 0.4MPa have been standardized.
-
It can also be used on linear axes and circular axes.
Installation precautions:
1. First, install the guide rail Ku Langba on the guide rail in the state of releasing the clamping. For the normally closed type, with the spacer inserted at the time of shipment, perform the opening and closing actions about 10 times, and then install the guide rail.
2. Then temporarily fasten the guide rail Ku Langba and the auxiliary gasket (if necessary) on the object such as the slide to be used. Screws with a strength grade of 8.8 or above are required, and the engagement length should be at least the nominal diameter of the thread × 0.9.
3. Next, after repeating the actions of clamping/releasing the clamping of the guide rail about 10 times, keep it in the clamping state.
4. In the state of clamping the guide rail, fasten the mounting screws with the specified tightening torque. Please refer to each product page for the tightening torque.
5. For products with a sealing ring, fasten the sealing ring fixing bolts in the temporarily fastened state.
6. Confirm that there is no interference between the guide rail Ku Langba and the shield base, etc.
7. When the MKRS leaves the factory, there is a spacer between the contact surfaces. Do not remove the spacer except during installation. If it is left for a long time with the spacer removed, the MKRS may not operate properly.
Piping instructions:
Shaft diameter φ12, M5, air consumption: 0.019L/cycle (ANR)
Shaft diameter φ16, M5, air consumption: 0.021L/cycle (ANR)
Shaft diameter φ20, M5, air consumption: 0.019L/cycle (ANR)
Shaft diameter φ25, M5, air consumption: 0.021L/cycle (ANR)
Shaft diameter φ30, M5, air consumption: 0.031L/cycle (ANR)
Shaft diameter φ40, M5, air consumption: 0.041L/cycle (ANR)
Shaft diameter φ50, M5, air consumption: 0.041L/cycle (ANR)
Shaft diameter φ60, M5, air consumption: 0.041L/cycle (ANR)
Control method: Pneumatic, normally closed
Opening pressure: 0.3MPa 0.4MPa 0.55MPa
Operating pressure: 0.65MPa
Response time: 0.06s
Clamping life: 5 million times
Operating temperature: -10℃～+70℃
Applicable shaft diameter: φ12mm～φ60mm
Applicable shaft hardness: Above 54HRC
Allowable dimensional deviation of applicable shaft diameter: -0.01mm～0mm
Main body material: Equivalent to SCr415, electroless nickel plating.
Installation dimensions:
Send Inquiry to This Supplier
You May Also Like
-
Imported Nbk Clamp From Japan, Air Pressure Normally Open Type Spool Clamping Pliers Mkr-1600-aUS$ 418.46MOQ: 1 Piece
-
Locking Device Mkr3200a for 32mm Diameter Spool, Imported Guide Rail Lock From Zimmer, Germany, Pneumatic Normally Open Clamping PliersUS$ 486.15MOQ: 1 Piece
-
Numax Optical Axis Clamp Mkr2500a Linear Axis Clamping Pliers, Normally Open Clamping UnitUS$ 209.23 - 223.08MOQ: 1 Piece
-
Shaft Diameter φ12mm Optical Shaft Locking Device, Numax Spool Clamp, Pneumatic Normally Closed Type Mkrs1200aUS$ 138.46 - 153.85MOQ: 1 Piece
-
Clamping Device for Spools, Ventilated Brake Type Locking Unit, Domestic Numax Optical Axis Clamp Mkr1200aUS$ 158.46 - 169.23MOQ: 1 Piece
-
Holder for Spool Mkr2000a, Domestic Numax Pneumatic Normally Open Type Clamp, Optical Axis Clamping PliersUS$ 198.46 - 209.23MOQ: 1 Piece
-
Linear Guide Rail Lock, Imported German Zimmer Pneumatic Normally Closed nc Clamping Pliers Mks8501aNegotiableMOQ: 0 Piece
-
Domestic Guide Rail Brake Mcps65s, Pneumatic Normally-closed Clamp, Linear Guide Rail Braking UnitUS$ 553.85 - 567.69MOQ: 1 Piece
-
Pneumatic Control Linear Guide Clamping Unit Mcps45s, Normally Closed Guide Rail Lock Clamp, Numax Guide Rail ClampUS$ 332.31 - 352.31MOQ: 1 Piece
-
Linear Guide Clamping Elements, Domestic Linear Guide Klb Mcps25 Normally Closed ClampUS$ 193.85 - 213.85MOQ: 1 Piece
