PA140 UL1278 Test Probe for Film Coated Wire
PA140 UL1278 Test Probe for Film Coated Wire
1. Introduction:
UL test probe for film coated wire designed according to UL1278 figure 8.2 (PA140A), UL398 figure 8.2 (PA170B) and UL507 (PA170D). It is mainly applied to access enamel coated wire. The handle is made by nylon and the tip is made by stainless steel.
2. Specification:
Rigid finger length |
101.6mm (4 inch) |
Rigid finger diameter |
Φ25.4mm (1 inch) |
Head radius |
R12.7MM (1/2 inch) |
Tail diameter |
31.5mm (1_1/4 inch) |
3. Picture:

Send Inquiry to This Supplier
You May Also Like
-
IEC60335-2-9 Test Hammer for Fragmentation Test of GlassUS$ 60 - 400MOQ: 1 Piece
-
IEC60065 Figure 9 Test Plug for Antenna Coaxial SocketUS$ 60 - 400MOQ: 1 Piece
-
IEC60950 Hardened Steel PinUS$ 60 - 400MOQ: 1 Piece
-
45V Control Panel for Accessability IP Test ProbeUS$ 60 - 400MOQ: 1 Piece
-
IEC60598-1 Figure 29 Test Chain With a Resistance of 2.5Ω/mUS$ 100 - 800MOQ: 1 Piece
-
IEC61032 Jointed Finger Probe for IP2X Testing With CNAS Calibration CertificateUS$ 150 - 400MOQ: 1 Piece
-
IEC60335 Finger Nail Probe With 50N Thruster and CNAS Calibration CertificateUS$ 150 - 400MOQ: 1 Piece
-
IEC61032 Test Probe A Used for IP1X TestingUS$ 90 - 400MOQ: 1 Piece
-
IEC61032 Test Probe C Used for IP3X TestingUS$ 90 - 400MOQ: 1 Piece
-
IEC61032 Test Probe D Used for IP4X TestingUS$ 90 - 400MOQ: 1 Piece