IEC61032 Jointed Finger Probe for IP2X Testing With CNAS Calibration Certificate
IEC61032 Jointed Finger Probe for IP2X Testing with CNAS Calibration Certificate
1. Introduction:
Design according to IEC61032 figure 2, meet the requirements of UL507, UL1278 figure 8 and EN60529 figure 2. This probe is intended to verify the basic protection against access to hazardous parts. It is used to verify the protection against access with finger.
2. Specification:
Diameter of dactylogryposis: |
12mm |
Length of dactylogryposis: |
80mm |
|
Diameter of baffle: |
50mm |
Length of baffle: |
100mm |
|
Material: Insulating material (baffle and handle), metal(dactylogryposis) | ||||
3. Figures
Send Inquiry to This Supplier
You May Also Like
-
IEC61032 Figure 6 Test Probe 2 With 12.5mm SphereUS$ 150 - 400MOQ: 1 Piece
-
IEC61032 Figure 7 Rigid Finger Probe for Test Probe 11US$ 90 - 400MOQ: 1 Piece
-
IEC61032 Finger Test Probe Figure 8 Test Probe 12US$ 60 - 200MOQ: 1 Piece
-
IEC61032 Figure 9 Short Pin Test Probe 13 With CNAS Calibration CertificateUS$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 10 Test Probe 14US$ 90 - 400MOQ: 1 Piece
-
IEC61032 Figure 11 Test Probe 17US$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 12 Small Child Finger Probe Test Probe 18US$ 60 - 200MOQ: 1 Piece
-
IEC61032 Figure 13 Children Finger Probe Test Probe 19 With 5.6mm FingerUS$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 14 Test Corn Probe 31US$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 15 Test Probe 32 With 25mm RodUS$ 60 - 400MOQ: 1 Piece
