IEC61032 Test Probe C Used for IP3X Testing
IEC61032 Test Probe C used for IP3X Testing
1. Introduction:
Designed according to IC61032 figure 3, meet the requirements of IEC60529-IP3, IEC60065,IEC60598 and etc. This rod is intended to verify the protection of persons against access to hazardous parts. It is used to verify protection against access with a tool.
2. Specification:
Length of test rod: |
100mm |
Diameter of test rod: |
2.5mm |
Dimater of stop sphere: |
35mm |
Diameter of handle: |
10mm |
Length of handle: |
100mm |
||
Material: Insulating material (handle, sphere), metal (test rod) | |||
Note:3N thruster for optional
3. Picture:
Send Inquiry to This Supplier
You May Also Like
-
IEC61032 Figure 9 Short Pin Test Probe 13 With CNAS Calibration CertificateUS$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 10 Test Probe 14US$ 90 - 400MOQ: 1 Piece
-
IEC61032 Figure 11 Test Probe 17US$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 12 Small Child Finger Probe Test Probe 18US$ 60 - 200MOQ: 1 Piece
-
IEC61032 Figure 13 Children Finger Probe Test Probe 19 With 5.6mm FingerUS$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 14 Test Corn Probe 31US$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 15 Test Probe 32 With 25mm RodUS$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 16 Test Probe 41 With 30mm ProbeUS$ 60 - 400MOQ: 1 Piece
-
IEC61032 Figure 17 Test Probe 43 With Calibrated Certificate Authorized by ISO17025 LabUS$ 60 - 400MOQ: 1 Piece
-
IEC60065 Figure 4 Test HookUS$ 60 - 400MOQ: 1 Piece
