IEC60335-2-24 Figure 102 Scratch Test Pin
IEC60335-2-24 Figure 102 Scratch Test Pin
1. Introduction:
The scratch test pin is designed according to IEC60335-2-24 fig. 102 and GB4706.13 Fig 102. It’s used to perform scratch tests on the accessible component surfaces of all protected cooling systems in appliances, including accessible surfaces that are in close contact with the protected cooling system.
2. Specification:
Radius of Tip |
1mm |
Diameter of Tip |
6mm |
Length of Tip |
8.6mm |
Length of Pin |
20mm |
Send Inquiry to This Supplier
You May Also Like
-
PA130A UL Accessibility Test Probe for Uninsulated Live PartUS$ 60 - 400MOQ: 1 Piece
-
UL Articulate Finger Probe with Web StopUS$ 60 - 400MOQ: 1 Piece
-
UL60950 Wedge Probe With CNAS Calibrated CertificateUS$ 60 - 1000MOQ: 1 Piece
-
IEC60335-2-11 Test Probe for Measuring Surface TemperaturesUS$ 60 - 400MOQ: 1 Piece
-
IEC 60065 Telecom Test ProbeUS$ 60 - 400MOQ: 1 Piece
-
IEC60335-2-9 Test Hammer for Fragmentation Test of GlassUS$ 60 - 400MOQ: 1 Piece
-
IEC60065 Figure 9 Test Plug for Antenna Coaxial SocketUS$ 60 - 400MOQ: 1 Piece
-
IEC60950 Hardened Steel PinUS$ 60 - 400MOQ: 1 Piece
-
45V Control Panel for Accessability IP Test ProbeUS$ 60 - 400MOQ: 1 Piece
-
IEC60598-1 Figure 29 Test Chain With a Resistance of 2.5Ω/mUS$ 100 - 800MOQ: 1 Piece