Module spare parts 1398-DDM-075

Focus on DCS, PLC, robot control system and large servo system.

Main products: various modules / cards, controllers, touch screens, servo drivers.

Advantages: supply of imported original products, professional production parts,

Fast delivery, accurate delivery time,

The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands

To avoid the risk of fire, do not use the nebulizer in the presence of a flammable anesthetic mixture combined with air or with oxygen or nitrous oxide. Do not use the nebulizer to aerosolize alcohol-based medications, which can ignite in oxygen-enriched air under pressure. 1. Select Menu > Nebulizer > Aerogen. 2. Select Time or Continuous. Selecting Continuous will deliver nebulized medication until medication delivery is stopped or runs out. The time and approximate volume of nebulized medication are shown in the table. This calculated volume is based on an CAUTION • • • • • 7 Procedures 2065490-001 7-3 average nebulization rate of 0.38 ml/min, but the actual nebulization rate of each individual nebulizer cannot be guaranteed and may vary significantly Time (min) 7 8 11 16 21 26 32 Volume (ml) 2.5 3.0 4.0 6.0 8.0 10.0 12.0 3. Select Start. Note To end a nebulizer treatment before the set time, select Stop. CARESCAPE™ R860 7-4 2065490-001 Pneumatic nebulizer The ventilator can compensate for additional flow introduced by a pneumatic nebulizer into the patient circuit. The displayed FiO2 measurement does not reflect the additional gas introduced to the patient through the nebulizer. Use of an external pneumatic nebulizer may significantly modify the mixture of gas that is delivered to the patient. Use of external pneumatic nebulization may significantly impact volume delivery and monitoring, decrease trigger sensitivity, and cause alarms if external flow is introduced and Pneumatic Nebulizer Flow Compensation is not used. When the Pneumatic Nebulizer Flow Compensation is On, flow and volume accuracy may be decreased. Leaks and flow sensor alarms may not be identified by the ventilator when Pneumatic Nebulizer Flow Compensation is On. 1. Select Menu > Nebulizer > Pneumatic. 2. Select the Flow value. • Set the flow value to match the amount of flow that will be introduced into the circuit. Flow setting is patient type dependent: 1.0 to 4.0 l/min for neonatal; 1.0 -12.0 l/min for adult and pediatric. 3. Select Start. A general message shows when nebulizer flow compensation is on. 4. Introduce the pneumatic nebulizer into the patient circuit. • For best results, introduce the pneumatic nebulizer into the patient circuit within approximately 15 seconds after selecting Start. To end a nebulizer treatment, turn the pneumatic nebulizer flow source off, then select Stop