Static Mechanical Load Testing Machine/Dynamic Mechanical Load Tester /PV Module Testing Machine

Static Mechanical Load testing machine/Dynamic Mechanical Load Tester /PV Module  testing machine

Testing standard

It's conform IEC61215-2:2016 testing standard 

Purpose

This test is to determine the ability of the module to withstand wind , snow , static or ice loads

The Main Technical specifications 

Testing Procedure

1.Equip the module so that the electrical continuity of the internal circuit can be monitored continuously during the test

2.Mount the module on a rigid structure using the method prescribed by the manufacturer including the mounting means (clips/clamps and any kind of fastener) and underlying support rails, if t here are different possibilities each mounting method needs to be evaluated separately , for all mounting methods , mount the module in a manner where the distance between fixing points is worst case, which is typically at the maximum distance. 3.On the front surface , gradually and uniformly apply the test load, load uniformity needs to be better than ±5% across the module with respect to the test load, maintain his load for 1h

4.Apply the same procedure as in step c to check back surface of the module or as uplift load to the front surface

5.Repeat step c and d for a total of three cycles

Customer Site Requirement

Sucker position figure show (2m×1m solar panel)

The Relative solar panel testing machine's show

2018 Year ShangHai Solar Energy Exihibition show 

Shipping ways 

Delivery time :

1. Received the deposit 30 work days after 

Sales-after Service 

1.Warranty time: 1 year

2.Support life-time technical support 

3.About the customer's questions, we will feedback on time 

Name Card