Not Go Gauge for G9 Base 7006-129A-1
Not Go Gauge for G9 Base 7006-129A-1
PURPOSE: To check dimension Gmin. of bases G9.
TESTING: Without using undue force it shall not be possible for the lamp to enter the gauge in such a way that the reference plane of the base meets the surface of the gauge in its entire length.
Sherry Xu
Tel:+86 18820263964
Email:sherryxu@jusdatest.com
Send Inquiry to This Supplier
You May Also Like
-
IEC61032 Figure 3 IP3X Degree 2.5mm Test Probe CUS$ 105 - 115MOQ: 1 Piece
-
IEC60529 Suffit IP40 and D Code 1.0mm Test Probe DUS$ 105 - 115MOQ: 1 Piece
-
IEC61032 Figure 4 Imitate a Wire 1.0mm Rigid Test Probe D With 1N ForceUS$ 130 - 135MOQ: 1 Piece
-
IEC61032 Figure 16 Sharp Test Probe 41 For Glowing Heating PartUS$ 100 - 110MOQ: 1 Piece
-
IEC61032/IEC60529 Degrees of Protection IP10-IP40 Against Access to Hazardous Parts Test ProbeUS$ 625 - 635MOQ: 1 Set
-
IEC/UL 61032 IP1X-IP4X Code Standard Test Sphere Probe, Jointed Finger ProbeUS$ 550 - 560MOQ: 1 Set
-
IEC 60335 Protection Against Access to Live Parts Test Probe B, Test Probe 13, Test Probe 41US$ 305 - 318MOQ: 1 Set
-
IEC60335-2-24 Figure BB.1 Apparatus for Water Evaporation and for Accumulation of FrostUS$ 720 - 750MOQ: 1 Piece
-
IEC60529 Waterproof Test IPX3 and IPX4 Hand Held Spray NozzleUS$ 660 - 680MOQ: 1 Piece
-
IEC 60335 /IEC 60601 Ball Pressure Tester For Heat Resistance of Non-metallic MaterialsUS$ 168 - 175MOQ: 1 Set

