IEC60335-2-11 Figure 101 Test Probe for Measuring Surface Temperatures
IEC60335-2-11 Figure 101 Test Probe for Measuring Surface Temperatures (surface temperature probe)
1. Introduction
The probe for measuring surface temperature is designed according to the requirement of IEC60335-2-11 figure 101 and IEC6335-2-6. It’s mainly used to test the temperature rise of the front and side of the cooker, oven and tumble dryers, 4N force is applied according to the standard.
2. Parameters
Copper Sheet | Φ5mm*0.5mm (thickness) |
Thermocouple | Φ0.3mm, K type made by OMEGA |
Insulated Pipe | Polycarbonate, inner diameter 3 mm, outer diameter 5 mm |
Handle | With 4N thruster |
3. Usage
1) . The test shall be carried out after the test corner test is completed.
2) . The equipment under test should be powered for 60mins or it reaches a steady state before test.
3) . The top of the probe was pressed against the surface of the device under test, and a 4 N force should be applied until the temperature was stable.
Send Inquiry to This Supplier
You May Also Like
-
IEC60335-2-14 8mm Diameter Cylindrical Rod Test Probe for BlenderUS$ 60 - 500MOQ: 1 Piece
-
IEC60335-2-14 φ40mm Cylindrical Rod Test ProbeUS$ 60 - 500MOQ: 1 Piece
-
IEC60335-2-30 Φ75mm Cylindrical Rod Test ProbeUS$ 60 - 500MOQ: 1 Piece
-
45VAC Electrical Control Panel for Accessability IPX ProbeUS$ 60 - 500MOQ: 1 Piece
-
IEC 61032 Test Probe A With 50mm Steel Sphere and Nylon HandleNegotiableMOQ: 1 Piece
-
IEC 60529 Jointed Finger Probe for IP2X TestingNegotiableMOQ: 1 Piece
-
IEC 61032 Test Probe C With 2.5mm RodNegotiableMOQ: 1 Piece
-
IEC 60529 IP4X Test Probe With 1.0mm Test WireNegotiableMOQ: 1 Piece
-
IEC 61032 Test Probe 2 With 12.5mm Test SphereNegotiableMOQ: 1 Piece
-
IEC60950 Clause 4.2.4 30mm Circular PlaneUS$ 80 - 200MOQ: 1 Piece
