FBM230 P0926GU

Brand: FOXBORO

Type:FBM230 P0926GU

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Module of PLC, DCS, ESD system card, the card is a vibration monitoring system, steam turbine control system module, the advantages of the gas generator spare parts brand: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts of our products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, mechanical, electronic manufacturing, automobile manufacturing, plastic machinery, electric power, water conservancy, water treatment/environmental protection, boiler heating, energy, power transmission and distribution and so on.

Expressed as an equation: CmdIn = [(User Input) – CmdOffset] * CmdGain NOTE: The range and resolution of CmdOffset is affected by the value of CmdGain. Its range covers the entire range of CmdIn. CmdSrc Analog, PWM CMD, or Command Variable CmdSrc selects the source of the command. It selects between using the command I/O connector analog input or PWM CMD digital input or the serial command parameter. 00 - Analog input sets command (default). 01 - PWM input sets command. 10 - Software Command Variable sets command (analog input Cmd proc). 11 - Software Command Variable sets command (PWMCMD input Cmd proc). Command ± DIpeak or ± 18,310 rpm Not supported over SynqNet. Sets the value of the command when CmdSrc is set to Command variable as opposed to the standard Analog or PWM CMD digital hardware inputs. The parameter units depend on whether the drive is in current or velocity control mode. When OpMode is set to Position, this variable is not used. CommMode SetupS2-2, SFD, 6-Step, Brush Selects the commutation mode of the drive. The following table describes the different values for this parameter. Mode Description SetupS2-2 DIP switch S2 position 2 selects between 6-step and SFD commutation, feedback. SFD Forces the drive to use SFD for feedback. 6-Step Forces the drive to use 6-step. Brush Forces 6-step commutation with CU, CV, CW = 1 1 0. CommOff ± 180 Degrees Offsets the origin for the electrical commutation angle in degrees. Normally set to zero. Non-zero allows matching non-standard motors or systems. WARNING In 6-step mode, this parameter must be set to 0 for proper operation. See also CommMode. Dinp1Pol Invert or Normal This parameter selects the polarity of the Dinp1. When this parameter is set, the input to the FPGA is inverted before it is used by the logic. This parameter affects the sense of the enable I/O input. The following describes the different values for this parameter. 0 - Normal 1 - Invert Dinp2Pol Invert or Normal This parameter selects the polarity of the Dinp2. When this parameter is set, the input to the FPGA is inverted before it is used by the logic. This parameter affects the sense of the InhibitCW I/O input. The following describes the different values for this parameter. 0 - Normal 1 - Invert Dinp3Pol Invert or Normal This parameter selects the polarity of the Dinp3. When this parameter is set