FCP270 P0917YZ

Brand:FOXBORO

Type:FCP270 P0917YZ

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Spare parts spare parts, the main DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Reuse of CPU modules replaced from redundant configurations within the same control network, might cause control network problems due to the MAC and IP address handling. See MAC and IP Address Handling in Redundant Configuration on page 49. Such reuse should not be fulfilled unless both the replaced module and the module previously acting together with it in redundant configuration are known to be restored from the previous mutual address swap. It is recommended to set up an IP-config session and use the “Restore factory settings” option subsequently followed by reassignment of the IP address or assignment of a new IP address.Exchanging a Defect RCU Link Cables Online In Configuration with BC810 If online change proves to be supported, after the caution above has been considered, and the BC810s are externally supplied with 24V the same steps as in configuration without BC810 can be followed. 

In Configuration without BC810 To exchange a RCU link cable in a redundant CPU configuration, perform the following steps: 1. Switch OFF the Power for the backup CPU. (Power on the primary CPU must still be On.) 2. Disconnect the RCU link cable from the backup CPU. 3. Disconnect the RCU link cable from the primary CPU. 4. Attach the new RCU link cable to the primary CPU, note the UPPER orientation on the cable. 5. Attach the other end of RCU link cable to the backup CPU. 6. Switch ON the Power to the backup CPU.Do not replace the RCU link cable online in a previous version than 5.0. The support for online replacement also depends on hardware Product Revision levels. Please consult Release Notes (3BSE021377*) for detailed information.Do not leave the primary CPU with the RCU link cable disconnected for a prolonged time. If a power fail occurs while the cable is disconnected, the primary CPU cannot perform a startup when the power come back.