Module Spare Parts UFC760BE43 3BHE004573R0043
Focus on DCS, PLC, robot control system and large servo system.
Main products: various modules / cards, controllers, touch screens, servo drivers.
Advantages: supply of imported original products, professional production parts,
Fast delivery, accurate delivery time,
The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands
| UFC760BE43 3BHE004573R0043 |
If the system is designed to work over wide input voltages, the voltage at the UVLO pin could exceed the voltage limit for the UVLO pin. In this case a zener diode can be connected between the UVLO pin and ground to prevent the UVLO voltage from rising above the maximum value. If the UVLO pin function is not desired, select R8 and R7 of equal magnitude greater than 100 kΩ. This will allow VIN to be in control of the UVLO thresholds. The UVLO pin may also be used to implement the enable/disable function. If a signal pulls the UVLO pin below the 1.43 V (typical) threshold, the converter will be disabled. 7.3.6 Short-Circuit Protection When the voltage across the sense resistor (measured on the ISEN Pin) exceeds 220 mV, short-circuit current limit gets activated. A comparator inside the LM3481 reduces the switching frequency by a factor of 8 and maintains this condition until the short is removed. 18 LM3481, LM3481-Q1 SNVS346F –NOVEMBER 2007–REVISED NOVEMBER 2014 Product Folder Links: LM3481 LM3481-Q1 Submit Documentation Feedback Copyright © 2007–2014, Texas Instruments Incorporated 7.4 Device Functional Modes The device is set to run as soon as the input voltage crosses above the UVLO set point and at a frequency set according to the FA/SYNC/SD pin pull-down resistor or to run at a frequency set by the waveform applied to the FA/SYNC/SD pin. If the FA/SYNC/SD pin is pulled high, the LM3481 enters shut-down mode.–NOVEMBER 2007–REVISED NOVEMBER 2014 Product Folder Links: LM3481 LM3481-Q1 Copyright © 2007–2014, Texas Instruments Incorporated Submit Documentation Feedback Feature Description (continued) Figure 28. Shutdown Operation in Synchronization Mode 7.3.5 Undervoltage Lockout (UVLO) Pin The UVLO pin provides user programmable enable and shutdown thresholds. The UVLO pin is compared to an internal reference of 1.43 V (typical), and a resistor divider programs the enable threshold, VEN. When the IC is enabled, a 5-μA current is sourced out of the UVLO pin, which effectively causes a hysteresis, and the UVLO shutdown threshold, VSH, is now lower than the enable threshold. Setting these thresholds requires two resistors connected from the VIN pin to the UVLO pin and from the UVLO pin to GND (see Figure 29). Select the desired enable, VEN, and UVLO shutdown, VSH, thre
Send Inquiry to This Supplier
You May Also Like
-
Module Spare Parts07AC91 GJR5252300R0101US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 07DC91C GJR5251400R0202US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 07EA90-SI GJR5251200R0101US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 07KR51 1SBP260011R1001US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 07KT98 GJR5253100R3160US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 086318-002 086318-501US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 086339-001 004707001474US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts 0880001-01US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts104X905BA603 G-95-149-H-9550US$ 1 - 100000MOQ: 1 Piece
-
Module Spare Parts106M1081-01US$ 1 - 100000MOQ: 1 Piece