SAM-DA-400/480-07B-P4N-F Servo Driver

Product Overview:

The freely configurable safety module has 20 safety inputs and 4 safety outputs, 4 signals, 2 clocks, and 2 grounding switch outputs, which can be diagnosed through the bus gateway and meet SIL 3, Cat Category 4/PL e, SIL 3 safety level, EN 50156, pluggable direct plug-in terminal blocks

Product specifications:

Product Type: Safety Equipment

Number of available expansion modules: 1 (maximum continuous current through PSR-TBUS: 4 A)

Overvoltage category: III

Pollution level: 2

Response time: maximum 30 ms (plus response time of PSR-TS-SDOR4)

Recovery time:<10 seconds

Maximum power consumption under rated conditions: 6372mW (at a=20, b=2, c=4, e=2, Iclock=100mA, Isignal=100mA, IOut/GND=2A, IOut/Out=2A)

Rated operating mode: 100% meets the conditions

Interface: USB

Contact information: 15359293870

WhatsApp:+86 15359293870

Contact person: KELLY

Email: geabbdcs@gmail.com   386353502@qq.com

Official website: http://www.geabb.com

TBUS DIN rail for expansion modules and bus couplers

Rated control circuit power voltage US: 18 V DC 30 V DC (including all tolerances, including residual voltage)

Rated control circuit power voltage US: 24 V DC (A1/A2)

Rated control power supply current IS: typical value 110 mA

Limit continuous current: maximum 6 A (for loop current paths A1/A1 and A2/A2)

Delay time: typical value of 20 ms (depending on load, in case of voltage drop of US)

Protection circuit: Yes, within the operating voltage limit range

Status display: 3x green LED, 1x red LED

Input Description: Number, HTL type

Input quantity: 10 (dual channel, up to SIL 3)

20 (single channel, up to SIL 2)

Input voltage range, "0" signal: 0 V DC 5 V DC (for safe shutdown)

Input voltage range, "1" signal: 11 V DC 30 V DC

Cable length: maximum 2000 m

Status display: 20 x green LED (1 LED per input)

Power consumption: typical value 4 mA

Number of outputs: 4 (safe semiconductor output, up to Cat. 4 (according to EN ISO 13849-1)

2 (negative switching output)

Precautions for protecting the circuit: Yes, within the operating voltage limit range

Short circuit protection: Yes

Output voltage:<5 V (low state)

Leakage current: maximum 2 mA

Maximum capacitive load: maximum 1 µ F (electronic components)

Limit continuous current: 2 A (per channel, see derating)