CB06551 PRD-B040SSIB-63

Brand:KOLLMORGEN

Type:CB06551 PRD-B040SSIB-63

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Module of PLC, DCS, ESD system card, the card is a vibration monitoring system, steam turbine control system module, the advantages of the gas generator spare parts brand: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Our main products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, mechanical, electronic manufacturing, automobile manufacturing, plastic machinery, electric power, water conservancy, water treatment/environmental protection, boiler heating, energy, power transmission and distribution and so on.

When not configured for a generator application, the 505E uses the programmed ‘Min Governor Speed Setpoint’ setting to determine which set of dynamic values are used by the Speed PID. The Speed PID’s off-line dynamics are selected when turbine speed is below the ‘Min Governor Speed Setpoint’ setting. The Speed PID’s on-line dynamics are selected when turbine speed is above the ‘Min Governor Speed Setpoint’ setting . (see Table 3-1). Optionally a contact input may be programmed to perform a “Select On-Line Dynamics” function. When this contact input is programmed the switching of the Speed PID’s dynamics is dependent only on the state of the programmed contact. The utility tie and generator breaker positions (gen applications), and the minimum speed setting status (non-gen applications) do not effect dynamics selection. When the programmed contact input is open, off-line dynamics are selected and used by the Speed PID. When the programmed contact input is closed, on-line dynamics are selected and used by the Speed PID. A relay can be programmed to indicate when On-Line Dynamics are selected and used by the Speed PID. Dynamic values are defined in the program mode and tunable at any time. Refer to the Dynamic Adjustments section in this manual. 

Configuration On-Line Dynamics Selected Off-Line Dynamics Selected Gen Set Both Brkrs Closed Either Brkr Open Not A Gen Set Spd > Min Gov Setting Spd