5SHY3545L0009 3BHB013085R0001 3BHE009681R0101 GVC750BE101

Brand:ABB

Type:5SHY3545L0009 3BHB013085R0001 3BHE009681R0101 GVC750BE101

Origin:  the Swiss

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Module of PLC, DCS, ESD system card, the card is a vibration monitoring system, steam turbine control system module, the advantages of the gas generator spare parts brand: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Our main products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, mechanical, electronic manufacturing, automobile manufacturing, plastic machinery, electric power, water conservancy, water treatment/environmental protection, boiler heating, energy, power transmission and distribution and so on.

For detailed information on TMR systems, see Reference 4, the IC66* Modular Redundancy Flexible Triple Modular Redundant (TMR) System User’s Manual. Supported option modules include IC697 LAN Interface modules, Programmable Coprocessor, Alphanumeric Display Coprocessor, Bus Controller for IC660/661 I/O products, Communications modules, I/O Link Interface, and all of the IC697 family of discrete and analog I/O modules. Triple Input Sensors Triple Genius Busses Triple PLCs Load a47059 Figure 1. Typical GMR System Configuration User Memory Program and data memory for the CPM 790 is provided by a memory board with 1 Mbyte of battery-backed CMOS RAM. 512 Kbytes of this memory is available for the user’s application program and data. This memory board is an integral part of the CPM 790 module and is included with the module. Flash Memory This module uses flash memory for storage of the operating system firmware (this module does not support storage of user program in the flash memory). This allows updates of the firmware without disassembling the module or replacing EPROMs. The operating system firmware is updated by connecting a PC compatible computer to the module’s serial port and running the Loader software included with the firmware floppy disk. Operation, Protection, and Module Status Operation of this module can be controlled by the three-position RUN/STOP switch or remotely by an attached programmer and programming software. Program and configuration data can be locked through software passwords or manually by the memory protect keyswitch. When the key is in the protected position, program and configuration data can only be changed by a programmer connected parallel only (to the Bus Transmitter module). 

The status of a CPU is indicated by the four green LEDs on the front of the module. Operating Temperature The CPM 790 requires forced air cooling for proper operation in ambient temperatures greater than 40
C (104
F). A fan capable of 70 CFM (including filters) should be located beneath slot 1 of the rack containing the CPU. Fan assemblies (IC697ACC721, IC697ACC724, and IC697ACC744) can be ordered for direct mounting on the IC697 rack. Refer to the applicable Programmable Controller Installation Manual for detailed information. Installation It is the responsibility of the OEM, system integrator, or end user to properly install the PLC equipment for safe and reliable operation. Product manuals provide detailed information about installation, startup, and proper use of the PLC equipment. The installation manual, shipped with your PLC programming software, describes how to properly install the equipment. If the PLC installation must comply with supported standards, such as FCC or CE Directives, please refer to the Installation Requirements for Conformance to Standards,