140ACO13000

Brand:140PLC

Type:140ACO13000

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

^{Spare parts spare parts, the main DCS control system of PLC system and the robot system spare parts,}

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

If the remote Master expects to receive or sends one complete 32-bit floating-point value for each count of one (1), then set this parameter to YES. When set to YES, the Slave driver returns values from two consecutive 16-bit internal memory registers (32 total bits) for each count in the read command, or receive 32-bits per count from the Master for write commands. Example: Count = 10, Slave driver sends 20 16-bit registers for 10 total 32-bit floating-point values. If, however, the remote Master sends a count of two (2) for each 32-bit floating-point value it expects to receive or send, or, if you do not plan to use floating-point data in your application, then set this parameter to NO, which is the default setting. You also need to set the Float Start and Float Offset parameters to appropriate values whenever the Float Flag parameter is set to YES. Float Start 0 to 9998 Defines the first register of floating-point data. All requests with register values greater-than or equal to this value is considered floating-point data requests. This parameter is only used if the Float Flag is enabled. For example, if you enter a value of 7000, all requests for registers 7000 and above are considered as floating-point data. Float Offset 0 to 9998 Defines the start register for floating-point data in the internal database. This parameter is used only if the Float Flag is enabled. For example, if you set the Float Offset value to 3000 and the float start parameter to 7000, data requests for register 7000 use the internal Modbus register 3000.

Additional Configuration Parameters as Master The Type parameter must be MASTER to configure these parameters. See Configuration Parameters Common to Master and Slave (page 40). Parameter Value Description Response Timeout 0 to 65535 milliseconds Specifies the command response timeout period in 1 millisecond increments. This is the time that a port configured as a Master waits for a response from the addressed slave before re-transmitting the command (Retries) or skipping to the next command in the Command List. The value to specify depends on the communication network used and the expected response time (plus or minus) of the slowest device on the network. Retry Count 0 to 10 Specifies the number of times a command is retried if it fails. Minimum Command Delay 0 to 32767 milliseconds Specifies the number of milliseconds to wait between receiving the end of a slave's response to the most recently transmitted command and the issuance of the next command. You can use this parameter to place a delay after each command to avoid sending commands on the network faster than the slaves can receive them. This parameter does not affect retries of a command, as retries are issued when a command failure is recognized.