Contact Platform Support
Help CenterDisassembly and Reassembly of GLL Shell and Tube Coolers
Related Products
1. Close the inlet and outlet valves, drain the oil and water, and then remove the cooler from the system.
2. Remove end cap, sealing gasket, return water cap at the other end and O-ring in sequence. Pull tube east from shell by fixed plate end.
3. When reassembling, check whether the gasket and O-ring are in good condition. When assembling, do not touch the work, adjust the seals properly, and conduct leakage test after all are installed. 1.0 Mpa compressed air is introduced from the oil side outlet. If there is water flowing from the water side outlet, the leakage will be in good condition. If the leakage is caused by the rupture of the copper tube, the two ends of the tube can be blocked by the pipe plug, and the number of heat exchanger tubes blocked does not exceed 10% of the total number.
Send Inquiry to This Supplier
You May Also Like
-
Structure and Working Principle of Shell and Tube CoolersNegotiableMOQ: 1 Set -
Using Essentials of Shell and Tube CoolersNegotiableMOQ: 1 Set
-
Faults and Solutions of GLC Shell and Tube CoolersNegotiableMOQ: 1 Set
-
Cleaning of GL Shell and Tube CoolersNegotiableMOQ: 1 Set
-
Special DT Electric Putter for Steel MillNegotiableMOQ: 1 Set
-
Latest Quotation of DT Series Electric Putter Hopper MatchingNegotiableMOQ: 1 Set
-
DTZ Electric Putter of Preferred Cost Performance RatioNegotiableMOQ: 1 Set
-
DTZB1000-500 Explosion-pro of Electric Putter for Coal MineNegotiableMOQ: 1 Set
-
Durable DTIA1000 Electric Putter Produced in Jiangsu ProvinceNegotiableMOQ: 1 Set
-
Manufacturer of Portable LT06 Electric PutterNegotiableMOQ: 1 Set
