Industrial High Velocity Gas Burners For Boilers

Mixer body:                  cast iron or cast aluminium
Gas tube:                      stainless steel 304 or 310
Pre-heated air(cast iron body)                 up to 450
Pre-heated air(cast aluminium body)            up to 300
Suitable for different types of gas:      NG/LPG/MG/TG/etc.
Brick standard refractory block, max.. temp.         1750
Capacity range                                           up to 1500kw
Excess air                                                 over 400%
Air and gas pressure at burner                               up to 40mbar
Excellent flame stability:                 excess air excess fuel on ratio firing

Low NOx level.                                    NOx
Wide capacity regulate ratio.                                     110
Easily replaced electrodes.      
Separated air and gas inlets, mixing at discharge point, no flashback.
Light-weighted, small-sized compact burners supplied with micrometer type gas flow adjuster, spark
 electrode and flame detector rod, peepsight, calibrated orifice plate flow meters to measure air and gas flows. 
 

Skbs burner abroad apply to metallurgyceramicsfire brickelectronic ceramicsspecial ceramics glass

aluminium industry etc.

For example:

Fibre insulated furnaces.     

Ceramic kiln.              

Heat treat furnaces.          

Top hat kiln.               

Truck-hearth furnaces.       

Billets reheating furnaces.    

Shuttle kiln.                

special ceramics kiln.         

Roller kiln.                

fire production kiln.         

Tunnel type furnaces(kiln).     

Skbs burners, model Skbs-xxx, are nozzle mix burners. Gas and air are mixed only at the point of discharge, thus flashback is prevented. This allows for adjustments to stoichiometric ratio and excess air. The air stream as the particular shape of the silicon carbide flame tube create a flame allowing for high heat penetration in the combustion chamber. Maximum ratings are obtained with 40mbar air pressure; operation with 400% excess air is possible when necessary. Skbs burners, model Ar-xxx, air recommended in chamber with fibre isolation. Calibration is simplified by pressure plugs which allow for knowing the exact gas and air flow(see charts below).