AP5010DN-AGN Mainframe(11n,General AP Indoor,2x2 Double Frequency,Built-in Antenna,No AC/DC adapter)
1. Indoor dual-band AP
2. IEEE 802.11a/b/g/n
3. 2*2:2 MIMO
4. Build-in 4dBi 2.4GHz antenna & 5dBi 5GHz antenna
5. PoE(802.3af)
6. 50mW Tx power for each band, a maximum rate of 600 Mbps
Features
WLAN features
- AP5010DN-AGN: complies with IEEE 802.11a/b/g/n.
- AP5010SN-GN: complies with IEEE 802.11b/g/n.
- AP5010SN-GN: maximum rate of 300 Mbit/s
- AP5010DN-AGN: maximum rate of 600 Mbit/s
- Maximum ratio combining (MRC)
- Maximum-likelihood detection (MLD)
- Data unit aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Rx only)
- AP5010DN-AGN: supports 802.11 dynamic frequency selection (DFS).
- Short GI in 20 MHz and 40 MHz modes
- Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to implement priority-based data processing and forwarding
- Automatic and manual rate adjustment (the rate is adjusted automatically by default)
- WLAN channel management and channel rate adjustment
- Automatic channel scanning and interference avoidance
- Service set identifier (SSID) hiding
- Signal sustain technology (SST)
- Unscheduled automatic power save delivery (U-APSD)
- Control and Provisioning of Wireless Access Points (CAPWAP) in Fit AP mode
- Automatic login in Fit AP mode
- Wireless distribution system (WDS) in Fit AP mode
- Mesh networking in Fit AP mode
Network features
- Compliance with IEEE 802.3u
- Auto-negotiation of the rate and duplex mode and automatic switchover between the Media Dependent Interface (MDI) and Media Dependent Interface Crossover (MDI-X)
- SSID-based VLAN assignment
- VLAN trunk on uplink Ethernet ports
- 4094 VLAN IDs (1-4094) and a maximum of 16 virtual APs (VAPs) for each radio
- AP control channel in tagged and untagged mode
- DHCP client, obtaining IP addresses through DHCP
- Tunnel data forwarding and direct data forwarding
- STA isolation in the same VLAN
- Access control lists (ACLs)
- Link Layer Discovery Protocol (LLDP)
- Uninterrupted service forwarding upon CAPWAP channel disconnection in Fit AP mode
- Unified authentication on the AC in Fit AP mode
- AC dual-link backup and VRRP hot backup in Fit AP mode
- Native IPv6
- IPv4/IPv6 dual stack
- IPv6 Portal
- IPv6 SAVI
- IPv4/IPv6 ACL
QoS features
- Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to implement priority-based data processing and forwarding
- WMM parameter management for each radio
- WMM power saving
- Priority mapping for upstream packets and flow-based mapping for downstream packets
- Queue mapping and scheduling
- User-based bandwidth limiting
- Adaptive bandwidth management (the system dynamically adjusts bandwidth based on the number of users and radio environment to improve user experience)
Security features
- Open system authentication
- WEP authentication/encryption
- WPA/WPA2-PSK authentication and encryption
- WPA/WPA2-802.1x authentication and encryption
- WAPI authentication and encryption
- Supports wireless intrusion detection system (WIDS) and wireless intrusion prevention system (WIPS), including rogue device detection and countermeasure, attack detection and dynamic blacklist, STA/AP blacklist and whitelist.
- DHCP Snooping
- DAI(Dynamic ARP Inspection)
- IPSG(IP Source Guard)
Maintenance features
- Unified management and maintenance on the AC in Fit AP mode
- Automatic login and configuration loading, and plug-and-play (PnP) in Fit AP mode
- WDS zero-configuration deployment in Fit AP mode
- Mesh network zero-configuration deployment in Fit AP mode
- Batch upgrade
- Local AP management through the serial interface or using Telnet
- Real-time configuration monitoring and fast fault location using the NMS
- System status alarm
BYOD
- Identifies the device type according to the organizationally unique identifier (OUI) in the MAC address.
- Identifies the device type according to the user agent (UA) information in an HTTP packet.
- Identifies the device type according to DHCP options.
- The RADIUS server delivers packet forwarding, security, and QoS policies according to the device type carried in the RADIUS authentication and accounting packets.
Locating Service
- Locates tags manufactured by AeroScout or Ekahau.
- Locates Wi-Fi terminals.
Spectrum Analysis
- Identifies interference sources such as bluetooth devices, microwave ovens, cordless phones, ZigBees, game controllers, 2.4 GHz/5 GHz wireless video and audio devices, and baby monitors.
- Works with eSight to locate and perform spectrum analysis on interference sources.
Specification
| Item | Description | |
|---|---|---|
| Technical specifications | Dimensions (H×W×D) | 50 mm×180 mm×180 mm |
| Weight | 0.4 kg | |
| System memory | 128 MB DDR2 32 MB flash memory | |
| Power specifications | Power input | DC 12V±10% POE Power: -48V DC PoE function in compliance with IEEE 802.3af and 802.3at |
| Maximum power consumption | AP5010DN-AGN: 9.5 W AP5010SN-GN: 6.0 W NOTE:The maximum power consumption depends on local laws. | |
| Environment parameters | Operating temperature | -10℃ to +50℃ |
| Storage temperature | -40℃ to +70℃ | |
| Humidity | 5% to 95% (non-condensing) | |
| Waterproof grade | IP31 | |
| Altitude | –60 m to 4000 m | |
Radio Specifications
| Item | Description | ||||
|---|---|---|---|---|---|
| Antenna type | Built-in antenna | ||||
| Antenna gain | AP5010DN-AGN: 2.4 GHz: 4 dBi 5 GHz: 5 dBi AP5010SN-GN: 4 dBi | ||||
| Maximum number of concurrent users | 128 | ||||
| Maximum transmit power | 17dBm You can adjust the transmit power from the maximum transmit power by 20 dB, with a step of 1 dB. NOTE:Actual transmit power depends on local laws and regulations. | ||||
| Maximum number of non-overlapping channels for AP5010DN-AGN | 2.4 GHz 802.11b/g 20MHz: 3 802.11n 20MHz: 3 40MHz: 1 | 5 GHz 802.11a 20MHz: 5 802.11n 20MHz: 5 40MHz: 2 | |||
| NOTE:The number of non-overlapping channels allowed varies in different countries. For details, see the Country codes & Channels compliance status | |||||
| Maximum number of non-overlapping channels for AP5010SN-GN | 802.11b/g 20MHz: 3 802.11n 20MHz: 3 40MHz: 1 | ||||
| NOTE:The number of non-overlapping channels allowed varies in different countries. For details, see the Country codes & Channels compliance status | |||||
| Channel Rate | 802.11b: 1, 2, 5.5, and 11 Mbit/s | ||||
| 802.11g: 6, 9, 12, 18, 24, 36, 48, and 54 Mbit/s | |||||
| 802.11n data rate: AP5010DN-AGN: 2.4 GHz and 5 GHz AP5010SN-GN: 2.4 GHz | |||||
| GI2=800ns | GI=400ns | ||||
| 20 MHz (Mbit/s) | 40 MHz (Mbit/s) | 20 MHz (Mbit/s) | 40 MHz (Mbit/s) | ||
| 6.5 @ MCS10 | 13.5 @ MCS0 | 7.2 @ MCS0 | 15 @ MCS0 | ||
| 13 @ MCS1 | 27 @ MCS1 | 14.4 @ MCS1 | 30 @ MCS1 | ||
| 19.5 @ MCS2 | 40.5 @ MCS2 | 21.7 @ MCS2 | 45 @ MCS2 | ||
| 26 @ MCS3 | 54 @ MCS3 | 28.9 @ MCS3 | 60 @ MCS3 | ||
| 39 @ MCS4 | 81 @ MCS4 | 43.3 @ MCS4 | 90 @ MCS4 | ||
| 52 @ MCS5 | 108 @ MCS5 | 57.8 @ MCS5 | 120 @ MCS5 | ||
| 58.5 @ MCS6 | 121.5 @ MCS6 | 65 @ MCS6 | 135 @ MCS6 | ||
| 65 @ MCS7 | 135 @ MCS7 | 72.2 @ MCS7 | 150 @ MCS7 | ||
| 13 @ MCS8 | 27 @ MCS8 | 14.4 @ MCS8 | 30 @ MCS8 | ||
| 26 @ MCS9 | 54 @ MCS9 | 28.9 @ MCS9 | 60 @ MCS9 | ||
| 39 @ MCS10 | 81 @ MCS10 | 43.3 @ MCS10 | 90 @ MCS10 | ||
| 52 @ MCS11 | 108 @ MCS11 | 57.8 @ MCS11 | 120 @ MCS11 | ||
| 78 @ MCS12 | 162 @ MCS12 | 86.7 @ MCS12 | 180 @ MCS12 | ||
| 104 @ MCS13 | 216 @ MCS13 | 115.6 @ MCS13 | 240 @ MCS13 | ||
| 117 @ MCS14 | 243 @ MCS14 | 130 @ MCS14 | 270 @ MCS14 | ||
| 130 @ MCS15 | 270 @ MCS15 | 144.4 @ MCS15 | 300 @ MCS15 | ||
| NOTE:Modulation coding scheme (MCS) index: determines the spatial flow quantity, modulation, coding rate, and data rate. Guard interval (GI): indicates the period in nanoseconds the radio listens between packets. | |||||
| Receiver sensitivity of the AP5010DN-AGN | 2.4 GHz 802.11b (CCK) -96 dBm @ 1 Mbit/s -91 dBm @ 2 Mbit/s -92 dBm @ 5.5 Mbit/s -88 dBm @ 11 Mbit/s | 2.4 GHz 802.11g (non-HT20) -91 dBm @ 6 Mbit/s -90 dBm @ 9 Mbit/s -89 dBm @ 12 Mbit/s -86 dBm @ 18 Mbit/s -83 dBm @ 24 Mbit/s -80 dBm @ 36 Mbit/s -76 dBm @ 48 Mbit/s -74 dBm @ 54 Mbit/s | 2.4 GHz 802.11n (HT20) -91 dBm @ MCS0 -88 dBm @ MCS1 -86 dBm @ MCS2 -81 dBm @ MCS3 -78 dBm @ MCS4 -74 dBm @ MCS5 -72 dBm @ MCS6 -71 dBm @ MCS7 -89 dBm @ MCS8 -88 dBm @ MCS9 -86 dBm @ MCS10 -82 dBm @ MCS11 -79 dBm @ MCS12 -74 dBm @ MCS13 -73 dBm @ MCS14 -71 dBm @ MCS15 | ||
Send Inquiry to This Supplier
You May Also Like
-
TYT Smarthome Gateway / Home Applainces Remote Comtroller in Zigbee Coordinator SystemUS$ 59 - 139MOQ: 1 Square Inch
-
Serial Wifi Module Wire Ethernet PCB Antenna Transparent Transmission WF-01US$ 1 - 10MOQ: 10 Pieces
-
Bulk Sms Gprs Gsm AT Command Sim5216 8 Ports Modem Pool 3g Modem ModuleUS$ 440 - 550MOQ: 1 Unit
-
RF DIN 7/16 Attenuator 50W 3dB/6dB/10dB/20dB/30dB/40dB/50dBNegotiableMOQ: 1 Piece
-
2015 New Design Bluetooth Transmitter for Smart TV ,home Audio SystemUS$ 11 - 13MOQ: 1000 Pieces
-
SIM800W for SIMCON GSM/GPRS ModuleUS$ 0.1 - 1MOQ: 1 Piece
-
Factory Price Good Performance 2.4g Wifi Internal Pcb Patch Antenna With 3M GlueUS$ 0.48 - 0.7MOQ: 100 Pieces
-
Wireless Serial 4 Pin Bluetooth Transceiver Module RS232 To Wifi Bluetooth ModuleUS$ 1 - 100MOQ: 100 Units
-
Round 3 Way Splitter Electric Log Splitter VK11093US$ 0.1 - 0.99MOQ: 5000 Pieces
-
High Strength FRP RadomeNegotiableMOQ: 100 Pieces