Infrared Security Sensor 868mhz PIR Detector FS-IP11-WA wireless

Specifications

1.2014 new burglar alarm system
2.wireless alam,no GSM Card,control your alarm by phone App
3. .Simple & Smart design

IP Alarm’s motion detector is what many call a PIR sensor (Passive Infrared) or PID sensor (Passive Infrared Detector).

In daily use, a motion sensor is one of the most important components in the surveillance of your home against break-ins. It is best placed in areas where you expect a thief to pass.

A little diode shows when the sensor is communicating with IP Alarm. All communication is done via the wireless technology, which the scanner and sensor utilize. You can see the sensor communicating when the light is on.

 

 

IP Alarm’s motion sensor is designed to work for up to 2 years on the same batteries. One of the tricks IP Alarm uses is that it detects less when you are home. This means that the sensor will typically only sweep things every 5 minutes. Should a thief pass the motion sensor it will of course react immediately.Therefore, if you 'play' with the sensor, you should know that there are a delay of up to 5minsbetween every reaction.

 

 

1. 1.      Persons who move across the motion sensor are seen best, so place the unit so that the thief passes by the sensor. See the illustration below.

Place the sensor ca 2-3m from the floor.

 

 

1. 1.      Placement near heat sources. Heat sources generate a lot of dust. In addition, the infrared sensor reacts to heat. This can cause errors and false alarms.
2. 2.      Avoid placing furniture and the like which the burglar can hide behind.

Avoid letting the sensor point directly at any windows.

 

 

 

 

The range of IP Alarm’s motion sensor is ca 100m in open country, but that number is not practically applicable. Depending on the walls, materials, etc., the range will vary.

 

To improve the signal, you can try either moving the sensor or perhaps moving the scanner. If neither of these options has any effect, you can extend the range by installing anIP Alarm signal extender.

 

 

 

 

We recommend disconnecting the hood and vacuuming the sensor on the inside once a year. Be careful not to damage the print card when you do. The life span of the batteries is up to 2 years. IP Alarm will let you know when they need changing.

 

 

 

 

IP Alarm’s motion detector is immune to smaller pets.The immunity covers pets smaller than ca 18kg and lower than 60cm.