METSO IOP111

Brand: METSO

Type:IOP111

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Electrostatic Sensitive Device Devices labeled with this symbol require special handling precautions as described in the installation section. GENERAL WARNINGS Equipment Environment All components, whether in transportation, operation or storage, must be in a noncorrosive environment. Electrical Shock Hazard During Maintenance Disconnect power or take precautions to insure that contact with energized parts is avoided when servicing. SPECIFIC WARNINGS Page 67: The AC 800M Controller and associated units must be unpowered and disconnected when being mounted onto a DIN-rail! Page 68: It is not allowed to manipulate CEX bus baseplates in a powered and running system. Before changing or removing a baseplate, all CEX modules on that segment must be removed. Page 72: AC 800M units must be disconnected from the power source before removing them from a DIN-rail! Page 72: It is not allowed to manipulate CEX bus baseplates in a powered and running system. Before changing or removing a baseplate, all CEX modules on that segment must be removed. Page 78: For PM861/PM864/PM865/PM866 insert the RCU Link Termination plug TB852, at the RCU Link connector. The termination plug must always be used for PM861/PM864/PM865/PM866 when running in single configuration. When a redundant processor is running in a single configuration use the RCU Link Cable TK851, if the RCU Link Termination plug TB852 is not available.

SPECIFIC WARNINGS (continued) Page 124: The CI862 baseplate has no locking device. Insert only the CI862 unit into this baseplate. Insertion of other unit types may cause damage to the equipment. Page 191: Before attempting maintenance or troubleshooting, read the Safety Summary on page 13. Failure to do so could lead to personal injury or damage to equipment. Page 198: It is not allowed to manipulate CEX bus baseplates in a powered and running system. Before changing or removing a baseplate, all CEX modules on that segment must be removed. Page 429: Explosion hazard - Substitution of components may impair suitability for Class I, Zone 2. Page 429: Explosion hazard - Do not replace batteries unless the power has been switched off or the area is known to be non-hazardous. Page 430: Explosion hazard - Do not disconnect equipment unless the power has been switched off or the area is known to be non-hazardous.