Super Series Water Purification System
Super Series Water Purification System
n Built-in online TOC monitor module î Independent TOC monitor module î It can be taken out to monitor any other ultrapure water. |
n Integrate with Ionpure EDI module î Without softener, chemical regeneration and replacing any DI cartridge, Its pure water’s resistivity will be above 5MΩ.cm(25℃), and TOC is lower than 30ppb. It will reduce the running cost and emissions of waste water. |
n Colorful touch screen î 7.0 inch high-resolution touch screen controlling system |
n Comprehensive monitoring system î 4 water quality sensor, 3 flow sensor î Quantified and timing dispense |
Features and Advantages
n 7.0 inch colorful high-resolution touch screen (16:9) controlling system, achieve finger-touch new experience.
n 4 way online water quality sensor, detect the quality of feed water, 2nd stage RO water, Edi water and ultrapure water respectively. And warn once water quality’s standard exceeding.
n 3 way flow sensor, count source water consumption and achieve quantified dispensing of Edi and ultrapure water.
n Integrate with Ionpure EDI module, the maximum output is 240 liters per day.
n Built-in independent online TOC monitor module (Super-TOC).
n Double stage reverse osmosis technology, assure 2nd RO water quality’s stability from different source water.
n Built-in 3 pump- 1st stage RO pump, 2nd stage RO pump and circulating sanitizing pump.
n All Cartridges replacing alarm function, based on time, flux and water quality, show cartridges’ used and residual life.
n Multiple alarm function: no feed water, full water, water quality’s standard exceeding, cartridge life ending and leakage.
n Auto self-flushing of RO membrane function (interval and continuous time setting), extend RO membrane’s life.
n Auto running data storing function with built-in SD card, and data can be exported through the USB interface.
n System continuous upgrading function through USB interface, and WIFI module is optional.
n Built-in perpetual calendar clock for cartridges and service setting.
n System sanitizing procedure, achieve the disinfection of ultrapure water’s tube and valve.
n System circulation function, achieve ultrapure water’s circulation to keep top quality of ultrapure water.
n Level II password, protect all the parameters setting, and prohibit any unauthorized setting change.
n Attached 50 liters water tank with conical bottom, including air filter, to prevent co2 and bacteria. Also external tanks is optional.
n Whole plastic shell with high-strength, avoid rusting and keep clean, to meet GLP standard.
n 4 door and easy-to-replacing cartridge design, convenient to maintain system and replace cartridges.
n Tube and adapter with NSF authorization and top quality, reduce TOC level and assure ultrapure water’s quality.
n Optimized pretreatment (including PP fiber, KDF and active carbon cartridge), effectively protect RO membrane.
n RO module with DOW’s membrane, ensure long life, stable operation and high desalinization rate.
n Ultrapure cartridge with DOW’s top polishing resin, ensure ultrapure water’s quality up to 18.2 MΩ.cm, with the lowest TOC level.
n Double wavelength (185&254nm) ultraviolet lamp module, restrain bacteria’s increase and reduce TOC.
n MWCO 5000D ultrafiltration module, effectively eliminate endotoxin, and suitable for precise cell cultivating and IVF.
n (0.45+0.1)µm double layer PES terminal disinfection filter, assure that terminal pure water is absolutely axenic.
Super series ultrapure water stem (tap water inlet)
With 7.0 inch touch screen system, 4 way water quality sensor, 3 way flow sensor for quantified dispensing, Ionpure EDI module, built-in TOC module, 2 stage RO and 3 pump system, Super series is top choice of ultrapure water for high grade experiments.
With tap water inlet, its output is 10 liters/hour. It can produce Edi water and ultrapure water. The Edi water’s resistivity is above 5MΩ.cm, and the ultrapure water’s resistivity absolutely reaches to 18.2MΩ.cm. It completely meets the highest grade I standard of ASTM, CAP, CLSI, EP and USP.
Flow Schematic
Specifications
Model |
Standard |
Eliminating endotoxin |
Low TOC |
Synthesizing |
Built-in TOC module |
|
Super 10F |
Super 10V |
Super 10FV |
Super-TOC10V |
Super-TOC 10FV |
||
Output- EDI water* |
10 liters/hour |
|||||
Output- ultrapure water |
Up to 2 liters/minute (when tank is full) |
|||||
Ultrapure water quality |
|
|||||
Resistivity(25℃) |
18.2MΩ.cm |
|||||
TOC* |
<10ppb |
<10ppb |
<3ppb |
<3ppb |
<3ppb |
<3ppb |
Bacteria |
<0.1cfu/ml |
|||||
Particle(>0.1μm) |
<1/ml |
|||||
Endotoxin |
N/A |
<0.001Eu/ml |
N/A |
<0.001Eu/ml |
N/A |
<0.001Eu/ml |
RNases |
N/A |
<0.01ng/ml |
N/A |
<0.01ng/ml |
N/A |
<0.01ng/ml |
DNases |
N/A |
<4pg/μl |
N/A |
<4pg/μl |
N/A |
<4pg/μl |
EDI water quality |
|
|||||
Resistivity(25℃) |
>5MΩ.cm |
|||||
TOC* |
<30ppb |
|||||
Silicon rejection rate |
>99.9% |
|||||
Feed water requirements |
Tap water, temperature:5-45℃,pressure:1.0-4.0Kgf/cm2 |
|||||
Dimension and weight |
Length×Width×Height:545×470×639mm, 28Kg |
|||||
Electrical requirements |
AC110-240V, 50/60Hz |
|||||
Power |
240W |
|||||
Standard configuration |
Main body (Including 1 set of cartridge)+50 liters PE tank (TOC model:+ built-in TOC module) |
|||||
Remarks:
*The value will be influenced by temperature and feed water’s quality.








Send Inquiry to This Supplier
You May Also Like
-
Ultrasonic Mini Fogger Mist MakerNegotiableMOQ: 1 Set
-
Mini HumidifierNegotiableMOQ: 1000 Pieces
-
Atomizing Ultrasonic Humidifier PartsNegotiableMOQ: 1 Piece
-
Filter of Soybean Maker/Juicer/Coffer MakerUS$ 0.5 - 5MOQ: 200 Pieces
-
Appication of Fog SystemNegotiableMOQ: 1
-
Humidifier PartsUS$ 0.1 - 0.5MOQ: 1000 Pieces
-
Water Mist SystemUS$ 3 - 8MOQ: 15 Pieces
-
Water Air Cooler Pad / Cooling Pad Production Line / Refrigeration Cooling PadUS$ 250 - 250MOQ: 10 Cubic Meters
-
SS Cold Fogging NozzleNegotiableMOQ: 500 Pieces
-
For Humidifying, Cooling, Disinfection and Deodorization,Keri Ultrasonic Mist Maker MU361US$ 7 - 9MOQ: 3000 Pieces

