50 Ohm Dummy Load 2W 7/16(DIN) Male Dummy Load RF Dummy Termination Load
50 ohm dummy load 2W 7/16(DIN) Male Dummy Load RF Dummy Termination Load
Termination loads absorb RF & microwave energy and are commonly used as dummy loads of antenna and transmitter. They are also used as match ports in many multiport microwave device such as circulator and directional coupler to make these ports which are not involved in the measurement be terminated in their characteristic impedance in order to ensure an accurate measurement.
Termination loads, also call dummy loads, are the passive 1-port interconnect devices, which provide a resistive power termination to properly terminate the output port of a device or to terminate one end of an RF cable. Telsto Termination loads are characterized by low VSWR, high power capacity and performance stability. Widely used for DMA/GMS/DCS/UMTS/WIFI/WIMAX etc.
Send Inquiry to This Supplier
You May Also Like
-
Feeder Cable Clamp For Base StationUS$ 1 - 2MOQ: 200 Pieces
-
Stainless Steel Standard Butterfly Hanger for Telecom EquipmentUS$ 1 - 2MOQ: 50 Pieces
-
Universal Snap in HangerUS$ 1 - 2MOQ: 50 Pieces
-
Stand-Off Adapters, 3/4″ or 3/8″ HolesUS$ 1 - 2MOQ: 50 Pieces
-
Three-Run Standoffs Bracket For Snp-in Hanger, Trapezoid Snp-in BoxUS$ 1 - 2MOQ: 50 Pieces
-
THREE – RUN STANDOFF BRACKET, 3/8″ or 3/4″ Standoff Angle AdapterUS$ 1 - 2MOQ: 50 Pieces
-
304 Stainless Steel Stackable Snap-in Hanger for 1-1/4″ Cable MountingUS$ 1 - 2MOQ: 50 Pieces
-
Low Loss 7/8 RF Coaxial Feeder Cable SupplierUS$ 1 - 2MOQ: 2000 Meters
-
2 Meter Jumper Cable 1/2″ Superflex With 7/16 Male DIN ConnectorUS$ 1 - 2MOQ: 200 Meters
-
Low PIM 1 Meter 1/2″ Super Flexible RF Jumper Cable With N Male to N Male ConnectorUS$ 1 - 2MOQ: 200 Meters

