Shoe Cover Dispenser to automatically wrap the shoe Medical

Shoe Cover Dispenser to automatically wrap the shoe Medical

Our shoe cover dispenser and shoe cover are widely used in Hospital, lab, dental, factory, nondust room and other sanitary places, comparing with the traditional shoe cover which you have to put on it by hand, our dispenser is able to wrap your shoes automatically so you do not need to wear shoe cover by hand anymore and you do not need to bow at all, what you need to do is just a step. What an easy! 

What is the Floor cleaning protecting equipment?

How to load shoe cover?

How to use:

1. Step into the dispenser
2. Press lightly downwards NATURALLY with even &
3. strong enough force. Step out with shoe cover wrapped on the shoe

Attention:

1. Make sure the length and width sides of shoe covers are in the right direction with the dispenser.
2. When loading more shoe covers, press the top T-Clip remaining inside the T-opening, and put down the new T-clips at the same time. Otherwise the new T-Clips cannot be loaded, and the dispenser may be broken if pressing hard.
3. Make sure that T-Clips are loaded to all corners and every ribbon on the T-Clips are untied.
4. Before using the dispenser, make sure that the top T-Clip is pulled out of the opening about 1mm by the rubber band. If not, pull out the top T-Clip slightly.
5. When using the dispenser, step in the center part of the dispenser and press with even and one-time strength. Otherwise the shoe cover releasing will be affected.
6. If the sliding block does not work well after using for a long time, spread some lubricating oil in the sliding slot to reduce the friction force.
7. The shoe cover releasing may be affected if shoe covers are loaded long time before using. It is better to load the shoe covers just before using.

Material of shoe cover: