Plastic Injection Molding Machine using Techmation Computer Erckerle Pump Phase Servo Motor

Plastic Injection Molding Machine using Techmation Computer Erckerle Pump Phase Servo Motor

1. Steel parts and castings : steel parts are 40 crmo,. the castings : QT500-7

2. Machine shelf : injection machine shelf adopts cutting by addvanced laser cutting machine and overall bending process, the skeleton square tube of table-board and bottom plate of the shelf shall adopt overall bending process without any splice weld     points, pole adopts full welding process.and high-strength multi-point.

3. Prevent oil leakage:seal component adoptd high-quality HALLITE SEAL.  its featured by not deformed from 40 degrees below     zero to 120 degree.anti-agings , and long serivice life.

4. The noise is low:  it is tested through special decibel meter,empty mold of closing pump is 61 db, high-pressure is 72db (industrial standard is 83db).

Machine Configuration

Servo Motor: Phase;

Servo Controller: Innovance;

Computer: Techmation (Or EST as required);

Hose: Falflex

Contactor: SSR Schneider

Connector: EATON

Valve: Yuken, Rexroth, Sunny or NHC

Stroke Switch: Honeywell or OMRON

Single Pole Switch: Schneider

Micro Switch: OMRON

Seal Component: VALQUA or HALLITE

Pressure Gauge: SKON

Hydraulic Motor: INTERMOT,  DANDUN or KPL

Lubrication System: HEGU

Skype: jiaxingren

Wechat: 13588071651

220T Injection Molding Machine  main technical datas as below;