SDVC35-MRJ Variable Frequency Intelligent Controller for Vibratory Feeder

CE certificate. 

Automatic Constant Feed Speed Control: Automatic output voltage adjustment in real-time to ensure constant preset feed speed regardss of weight change of the workpieces.

Automatic Frequency Adjustment: Automatic output frequency adjustment in real-time to make sure the load is always working at its rest frequency.

Automatic Resonant Frequency Search: Search out and output the ressonant frequency of the load. other related parameters are also set automa

Counting: Count the number of the feed material. The controller will slownr stop when counting up to the preset value.

RS485 Communication: All parameters of the controller can be adjusted via RS485

Network Communication: All parameters of the controller can be adjustedia network communication

Output Current Display: Output current can be displayed in real-time

Firmware Upgrade: Firmware can be upgraded remotely.

Type of Control Output: Push-pull type.

Automatic Switch Sensor Type Recognition: The controller can recoggnize and adapt to both PNP and NPN-type switch sensors.

Sync Output: Sync the output waveform of the slave controller with that ofaster controller to the same frequency and phase to avoid beat effect.

Remote Speed Control: The controller's output voltage can be adjusted remotely by an external potentiometer, a PLC, or a DC signal.

Overvoltage Protection: If the input voltage is too high, the power supply of the controller will be shut down automatically to protect itself.

Digital Overheat Protection: If the internal temperature of the contcroller gets too high, the controller will stop its output to protect itse

Overcurrent Protection: If the output current exceeds its rated value, the controller will stop its output to protect itself and the load

Restorable Short Circuit Protection: If the output of thecontroller is short-circuited, the controller will shut down its output toprotect itself and the load But the fuse inside will not be blown So when there is no short circuit at the output side the controller will work again after power on