Wheat Straw Bean Stalks Wood Chip Hammer Mill Crusher

Wheat Straw Bean Stalks Wood Chip Hammer Mill Crusher

Wood Hammer Mill Introduction
Wood hammer mill is the most widely applied grinding machine in wood processing industry, and its extensive recognition and popularity lies in the scientific structure. Our wood hammer mill is innovatively designed in the space between hammers and rotors, which makes sure hammers are perfectly protected from metal and other hard residue entry. For grinding wood materials, wood hammer mill tends to welcome to crush soft and small materials such as tree branches, straws, herb, crop stalks, etc. whose diameter is less than 50mm. It has great crushing efficiency and can ensure the end materials diameter of 3mm-5mm.

Raw materil of Wood Hammer Mill  

Wood Hammer Mill Technical Parameters

Advantages of Wood Hammer Mill  
1.The hammerhead is cast by new technology to ensure abrasion resistance and impact resistance.
2.By adjusting the gap between the hammer and the sieve, coarse grinding and fine grinding can be performed at the same time.
3.With is equipped with a blower, the crushed sawdust can be collected and transported directly to the wood pelletizing process.
4.The particle size can be adjusted according to customer requirements.
5.The seal structure avoids dust pollution and dust leakage.
6.The structure is compact, low consumption, low wear rate; a uniform crushing effect and convenient maintenance make the wooden hammer mill an upgraded product.

Working principle of Wood Hammer Mill  
When the wood falls into the crushing cavity from the feed inlet, the rotor with a hammer rotates at a high speed. The material is crushed immediately by the impact of the high-speed rotating hammer. The crushed material with a diameter smaller than the diameter of the sieve will leak out from the sieve. However, the large particles will be hit by the rotating hammer again until they become small enough to be squeezed out of the screen holes.

What is the sawdust can do ? 

Making charcoal wood briquettes for burning or home heating 

1. Crush the raw material into small pieces (size is about 3-5mm), if your raw material size is big;
2. Dry the material by the dryer machine or dried it in the sun, till the moisture is less than 8%- 12%; if your raw material moisture content is higher than 8-12%;
3. Put the dried material into feeding inlet of briquette machine by worker or by screw conveyor;
4. Produce the briquette from the dried material without any additive by the wood briquette machine.

5. Carbonized the briquette and become charcoal briquette. 

Dryer (click the picture get more inforamtion )

wood briquette machine (click the picture get more inforamtion )

 Carbonization stove (click the picture get more inforamtion )