Hot sale vinyl injection-type anchor adhesive injection glue gun

Hot sale vinyl injection-type anchor adhesive injection glue gun

Injection Anchoring Adhesive is a two-component, Styrene Free system for use as a high strength, non-shrink anchor grouting material. Its advantage on steel bar planting has been proved by many testimonies. Compares with other adhesive, it is a new high performance, Eco-friendly anchoring adhesive which has strong bonding strength and high efficiency as well as irritation free and low odor.

 Advantages:

1.High bonding strength, good flexible performance similar as embedded. 
2.Ageing resistance, good heat tolerance and does not creep at ambient temperature;
3.Low sensitivity in moist condition with long term load stability;
4.acid-resistant, good shock resistance, stress-free fixed;
5.good thixotropy, particularly applicable to the sides or top surface anchoring;
6.two-cylinder direct-mix package, with a dedicated glue gun without manual mixing.

Application:

All concrete building without embedded steel bar.
Reinforcement and reconstruction of buildings with concrete.
Reinforcement and reconstruction of Railway, Road, Bridge, Water resources, Tunnel, etc.
Reinforcement for equipment, pipeline installation, supports of curtain wall.

Technical Parameter:

1. Basic parameters 
1) Appearence 
Part A (main): white cream
Part B (hardener): red cream / grey cream
2) Mixed Viscosity: 18-22Pa.s
3) Hardened density: 1.50±0.10g/cm3
4) Mixing ratio (Volume ratio): 
360ml(5:1) 390ml(3:1) 585ml(3:1) 650ml(1:1) 400ml(1:1) 420ml(2:1)
5) Shelf time: 18 months