TPHD1616 High Speed Drilling Machine

The machine is mainly used in steel structure drilling in construction, bridge, tower etc., and can be use din pipe and plate of boiler, petro line, baffle plate and round flange. And the machine can be used drilling through-hole, blind hole, ladder hole, chamfer for hole-end with Max clamp scope 1600×1000mm.

1.1. CNC slide way drilling spindle (Z axis) with work piece of stroke is pre-set, realized auto switch. It can drill not only through-hole, but also blind-hole with characteristic of high efficiency, simple-structure, low-cost maintenance, easy operation etc.

1.2. This machine the work piece is tight by hydraulic clamp cards, the operation of the workers with foot switch control, easy to operate, and effort; the largest single piece of up to 1600×1600mm, small work pieces can be clamped to the four corners of the table, and can significantly shorten the production preparation period, improve production efficiency.

1.3. This machine is a total of three CNC axes: gantry mobile (x-axis);drilling power head in the mobile gantry beam (y-axis); of the advance and retreat movement of the spindle (z axis). Each CNC axes using precision linear rolling guide oriented AC servo motor and ball screw drive. The movement is flexible, accurate positioning.

1.4. This machine is more than a splint group, clamping it was easier to design are taken into consideration when processing circular plate of the boiler industry, hole-intensive, so the work on stage scale steel ruler and as mall support block, according to the work piece position of the hole size mobile support blocks, to escape the position of the hole.

1.5. CNC adopt SIMENS 808D control, equipped with a host computer to facilitate the storage and input of the work piece program, easy to operate.

1.6.  The configuration of the machine tool ball screws, linear guides, electrical, servo motor, inverter, etc., are well-known foreign manufacturers supply. Failure Boot rate.