Recycle Nano Electrolyte Gel Filled Motorcycle Battery 5OPzS350 Anti Heat

Delivery Time:30 days
Certification:CE/UL/ISO

Recycle Nano Electrolyte Gel Filled Motorcycle Battery 5OPzS350 Anti Heat

Specifications:

Nominal Voltage		2V
Nominal Capacity (C20)		350Ah (1.80V @ 20℃)
Dimension	Length	124mm
	Width	206mm
	Height	470mm
	Total Height	525mm
Weight(With Electrolyte)		Approx. 27 kg
Terminal		M8
Internal Resistance		Full charged@20℃: 0.00075 Ohm
Max Charging Current		70A

Description:

● Designed life for floating charge is 20 years according to IEC60896-11;

● Rubber separator with floating electrolyte technology;

● High strength ABS material for cover and SAN material transparent container;

● Wide temperature scope of application (-15~45℃);

● Best temperature of application (20±5℃);

● Special filter installation for acid fog proof;

● Transparent container, convenient to observe;

● Super long service life.

Applications:

● Telecommunications

● Cable Television

● Electric Utility

● Alarm & Security system

● UPS

● Control Equipment

● Medical Equipment

● Railroad Utility

● Photovoltaic System

● Alternative Energy System

● High Power Backup Supply

Maintenance

● The battery should be kept clean and dry. Wring tight the acid-proof bolt, and cover it.

● The installation site should be kept clean and dry. With the best temperature about 20 C, the battery room should be given ventilation once weekly.

● No over charge or over discharge for normal operation.

● The temperature should not exceed 40 C in the usual use. No hot feeling when touching the joint point and the terminal.

Precautions

● The battery pack has high voltage, so direct contact or indirect contact through wet objects with any conducting cable may result in vital injury. The battery pack is energy-storing equipment, so never short-circuit the battery pack during operation and maintenance in any way.

● Only qualified and professional personnel are allowed to install, operate and maintain the equipment.

● Using the batteries of the same model

Use batteries of the same model in the same set. Using different models in the same set will damage the equipment.

● Acid-corrosion danger

No great impact shack and dump-age of the battery when handling and operating. Otherwise, it may cause the leakage of the acid.

on mixing the acid, please wear the protections: face-guard, acid-proof shoes, acid-proof glove, acid-proof clothes & eye-protector.

never have the acid spill on skin, eyes without any protections & also no acid on equipment or floor.

Tips

● Heat kills batteries. Avoid installation and/or operation in close proximity to heat sources of any kind. While the operating temperature range is -15°C to 45°C, and ideal service life will be realized when the battery is operated in an ambient temperature of 20°C (for cyclic service applications, a range of 5°C to 35°C is recommended).

● If the battery is to be installed in an air or water tight container, ventilation must be provided. Batteries may generate ignitable gases which must not be contained. Because of this, batteries should not be installed near spark producing equipment.

● Battery life is dependent on its operating conditions. Please refer to the life curves published in this Applications Manual. These curves represent typical results under optimum operating conditions. Actual life will vary greatly due to variability of these conditions. To obtain optimum battery performance for standby service, CGB recommends that within five years of use, the batteries be replaced.

● Observe the external appearance of the battery. If, at any time, cracks, deformation or other damage is found on the battery case or cover, or if any leakage of the electrolyte is observed, immediately replace the battery.