Single - Mode RS422 to Fiber Optic Converter / Serial to Fiber Modem / RS232 To RS485 Converter

Single - mode RS422 to fiber optic converter / serial to fiber modem / RS232 To RS485 Converter

Introduction:

The Model271 Series converter is equipped with a multiple interface circuit that can handle RS-232, or RS-422/485 serial interfaces and multi-mode or single- mode fiber. Model271 converters are used to extend serial transmission distance up to 2-5 km (multi-mode fiber) or up to 20-120 km (single- mode fiber). Note that the RS-232 and RS-422/485 interfaces cannot be used on the same Model271 at the same time to convert to fiber. Auto Baud Rate Detection.

Features:

1.          Auto sense serial signal rate, zero delay automatic transmit

2.          500Kbps the highest baud rate

3.          Supply three interface (RS232/485/422)

4.          Multi-mode 2KM, signal-mode 20~120KM

5.          Compact Size

6.          Decreases Signal interference

7.          DIN Rail or Wall-mounting

Specification:

RS-232/485/422 side

Standard: EIA RS-232, RS-485, RS-422

Connector: Terminal Block

RS-232 Signals: Tx, Rx, GNG

RS-422 Signals: T+, T-, R+, R-

RS-485 Signals: T+, T-

Baud rate: 0-500kbps

ESD Protection: 15KV for all signals

Optic fiber side

Fiber Connector: SC, FC or ST optional

Cable Requirements

Single-mode: 8.3/125, 8.7/125, 9/125 or 10/125μm

Multi-mode: 50/125, 62.5/125, or 100/140μm

Transmission

Single-mode: 20, 25, 40, 60, 80, 100, 120KM optional

Multi-mode: 2, 5KM

Wavelength

Single-mode: 1310nm

Multi-mode: 850nm

Tx Output

Single-mode: >-5dBm

Multi-mode: >-5 dBm

Rx Sensitivity

Single-mode: -25dBm

Multi-mode: -25dBm

Point-to-Point Transmission: Half-duplex or full-duplex

Ring Transmission: Half-duplex

Physical Characteristics

Case: Iron

Dimensions: 100*69*22mm

Environment

Operating Temperature: -10°C to 60°C

Storage Temperature: -40°C to 85°C

Relative Humidity: 5 to 95%

Power Requirements

Input Voltage: 9-36VDC

Consumption: 120mA

Warranty: 5 Years

Approvals: FCC, CE, RoHS approvals