Markerbot polycarbonate 3d printer filament 1.75mm or 3mm good gloss

PC Filament 1.75 / 3.0 mm 

1, Specifications : 1.75&3.0.

2, Manner and packing: use vacuum package, the net weight 1.0KG.

3, High temperature resistant, can resist the ultraviolet rays.

4, High transparent, good transmission of light, good gloss.

5, Strength with toughness.

6, Working temperature 230°C -280°C.

We have PLA , ABS, HIPS, PC,Nylon( PA), POM, PETG, PVA,WOOD,FEXIBLE Filament

1, Manner and packing: We use plastic tray, the net weight 1.0KG, we put desiccant in it, use vacuum package, every Tray into  a small box, and the each 8 small box into a master carton.

2, Plastic tray: diameter 160mm, axle hole32mm, overall height 90mm.the corresponding carton35.8×35.8×22.5cm

 Diameter 200mm, axle hole 56mm, overall height 70mm. the corresponding carton 43.5×43.5×18cm

Applicable models: Suitable for Markerbot, RepRap,Cubify and UP 3D Printer.

Quality Control :

 1, All of Our 3D Printer Filament are 100% virgin material, never use recycled material or regrind material, and all had achieved the latest REACH certificate.

 2, Before the mass production, our engineer always do the test to make sure that sure that each batch of new raw materials must be printed by 3D printer.

 3, The Laser diameter runs automatically to control the diameter of the filament and keeps it in a right    range of 1.75 / 3.0mm, and our engineer will adjust it immediately when it alarms to indicate of wrong size, and this unqualified filament will be cut off and never use it.

 4, We to keep the filaments dry, each roll of filament is packed in a vacuumed poly bag with a desiccant    inside of it.