MOBILE TOWER

Over three decades of industry experience in this domain enables MEGATROto successfully undertake designing, fabrication, galvanizing and erection workof MOBILE  TOWERS. Our mobile toewr with details asfollow:
A) General Specification
The Specification defines the characteristics and performance requirements ofthe Mobile base station unit to be supplied.
Manufacture and workmanship will comply withGB,  BS 449 or AISC
B) Technical Specification
The Trailer with tower:
2.1 General Description: The Mast is mounted on trailer as detailed below:
Weight on axels: weight on axels during transport is compliance to TransportMotor Traffic regulations.
Height of the trailer with tower: height of the vehicle during transport oftower is compliance to the Maximum height restriction.
Length of the trailer: length of the vehicle is restricted as much as possibleand it is compliance to regulation made by Ministry of Transport.
Lighting system:  complete with adequate reflectors and stop lights.
Brake system: is based on using air brake system for front axle.
Max. Mast Height from ground = according to the model.
Installation time is less than 3 hrs.

2 Mast
General Description: The Mast is mounted on trailer as detailed below:
The Supporting structure is a trailer approved for road use. The telescopicmast, which is fixed to the frame, is anchored to the support feet by sets ofguy wires and anchor rods.
Mast climbing facilities: One of the mast faces is provided with step rungs tofacilitate the mast climbing.
Rigging of antennas & feeder: Antenna mounts are provided with the mast tofacilitate mounting of both RF or MW antennas. Antenna feeders will run throughclicks attached to mast.
Rigging of antennas & feeder: Antenna mounts are provided with the mast tofacilitate mounting of both RF or MW antennas. Antenna feeders will run throughclicks attached to mast.
The Antenna mounts, in Steel, 3 no cellular antennas (3m pole) & 2 nor MWantennas.