Best price Oil extractor machines

Best price Oil extractor machines 

Product Description for Oil extractor machines

1. The raw material is conveyed to extractor hopper through feeding scraper, then enter into extractor through auger,after solvent spray,soak extract and drain off,fresh solvent spray and washing again(solvent and raw material flow reverse.

2. In final,the extraction meal after eventually drain fall into the wet meal scraper conveyor ,then transported to the DTDC desolventizer through auger.

3. The meal after desolventizing is conveyed into the meal storeroom through auger and scraper; strong mixing oil after removing impurities by cyclone hydraulic separator,enter into mixed oil tank sedimentation to remove impurities again,then start the first-evaporator.

4. Desolventizer (DTDC)according to SCHAMERHER theory,through pre desolventizing,mixed desolventizing ,desolventizing,drying and cooling 5 sections which are filled with a lot of direct and indirect steam,get rid of solvent, through access to a lot of heat,cold air make meal’s moisture and temperature meet the need of storage,hydrolysis of urea enzyme to fulfill the requirements of good forage.

5. The mixed oil which is purificator,after the flow measurement,first start the first-evaporation,the heat source of first evaporation is comes from DTDC Desolventizer’s second steam and negative pressure condenser jet pump’s residual steam. The solvent is desloventizered by first-evaporation enter into vacuum condenser through separator.

6. Adopting negative pressure desolventizer can reduce mixed oil’s boiling point,improve the utilization rate of heat.The concentration of mixed oil after first-evaporation can achieve 70%,mixed oil flow by itself from first-evaporation to second-evaporation.

7. Second-evaporation use indirect steam to heat,the steam consumption of Second-evaporation is very low.the concentration of mixed oil can up to 95%.The mixed oil enter into stripper through pump,mixed oil is slowly fall down from the top of stripper to inside,at the same time inject direct steam from the bottom of stripper,get rid of the residual solvent,at the top of stripper,the mixed steam connect with vacuum condenser,this condenser is connect with inject pump,to make sure that the stripper is operated under negative pressure,at the bottom of stripper install liquid controller,make sure liquid seal and oil flow is stability.

Product Show for Oil extractor machines

Our Service for Oil extractor machines

soya bean oil expeller

almond oil extraction machine

bran oil extraction machine