ADI HMC7044LP10BE High Performance, 3.2 GHz, 14-Output Jitter Attenuator with JESD204B TI CREE XILINX MACOM

HMC7044LP10BE

High Performance, 3.2 GHz, 14-Output Jitter Attenuator with JESD204B   Recommended for New Designs  Aerospace and Defense

HMC7044LP10BE Features and Benefits

Ultralow rms jitter: 44 fs typical (12 kHz to 20 MHz) at 2457.6 MHz

Noise floor: −156 dBc/Hz at 2457.6 MHz

Low phase noise: −141.7 dBc/Hz at 800 kHz, 983.04 MHz output

Up to 14 LVDS, LVPECL, or CML type device clocks (DCLKs) from PLL2

Maximum CLKOUTx/CLKOUTx and SCLKOUTx/SCLKOUTx frequency up to 3200 MHz

JESD204B-compatible system reference (SYSREF) pulses

25 ps analog, and ½ VCO cycle digital delay independently programmable on each of 14 clock output channels

SPI-programmable phase noise vs. power consumption

SYSREF valid interrupt to simplify JESD204B synchronization

Narrow-band, dual core VCOs

Up to 2 buffered voltage controlled oscillator (VCXO) outputs

Up to 4 input clocks in LVDS, LVPECL, CMOS, and CML modes

Frequency holdover mode to maintain output frequency

Loss of signal (LOS) detection and hitless reference switching

4× GPIOs alarms/status indicators to determine the health of the system

External VCO input to support up to 6000 MHz

On-board regulators for excellent PSRR

68-lead, 10 mm × 10 mm LFCSP package

HMC7044LP10BE Product Details

The HMC7044 is a high performance, dual-loop, integer-N jitter attenuator capable of performing reference selection and generation of ultralow phase noise frequencies for high speed data converters with either parallel or serial (JESD204B type) interfaces. The HMC7044 features two integer mode PLLs and overlapping on-chip VCOs that are SPI-selectable with wide tuning ranges around 2.5 GHz and 3 GHz, respectively. The device is designed to meet the requirements of GSM and LTE base station designs, and offers a wide range of clock management and distribution features to simplify baseband and radio card clock tree designs. The HMC7044 provides 14 low noise and configurable outputs to offer flexibility in interfacing with many different components including data converters, field-programmable gate arrays (FPGAs), and mixer local oscillators (LOs).

The DCLK and SYSREF clock outputs of the HMC7044 can be configured to support signaling standards, such as CML, LVDS, LVPECL, and LVCMOS, and different bias settings to offset varying board insertion losses.

Applications

JESD204B clock generation

Cellular infrastructure (multicarrier GSM, LTE, W-CDMA)

Data converter clocking

Microwave baseband cards

Phase array reference distribution