Infusion Set With Lower Price With CE& ISO

infusion set with lower price with CE& ISO                    

 Infusionset components  

   Key:

1   protective cap of closure-piercing device         7    fluid filter

2   closure-piercing device                                    8    tubing

3   air inlet with air filter and closure                      9    flow regulators

4   fluid channel                                                    10  injection site

5   drip tube                                                          11  male conical fitting

6   drip chamber                                                    12  protective cap of male conical fitting

                                                                                          (or work with intravenous needle)

 a    Closure of the air inlet is optional.

 b   The fluid filter may be positioned at other sites, preferably near the patient access. Generally, the fluid    filter used has a  nominal pore size of 15 µm.

 c    The injection site is optional.

Products specification:

 Material for main components

 Directions for Use

 -   Close the roller clamp.

-   Punch the lancet into the container.

-   Open the roller clamp and expel the air bubbles.

-   Close the roller clamp.

-   Guide the needle into the vein.

-   Adjust the flowing rate.

-   Infusion set with air-inlet device in use with the rigid container.

  Caution

 -       Read ‘direction of use’ carefully before use.

 -     Do not touch the needle

 -     This set is only for single use.

 -     Do not store under direct sunlight or extreme temperatures.

 -     Keep dry

 -     Do not use if package is damaged or open

 -     Do not use after expiry date

 -     Discard after use.

 -     Never use if any part of the set is disconnected, or if protective cap is detached or loose

Transportation and Storage 

-This product is strictly prohibited during transport wrestling touch, rain, stress.
- The product should be stored in less than 80% relative humidity, temperature -10 °C ~ 40 °C, non-corrosive gases and well-   ventilated room.
-Laying layers not more than seven layers.

Pictures of products

 More detials

Professionnal factory

Quality management system certificate: