Micro Duct Coupler For Micro Duct Porject

Micro Duct Coupler For Micro Duct Porject

1.Specifications

 1.1  Clear Connector for MicroDuct 
 1.2  Easy installation 
 1.3  Can be connected and disconnected 10 times 
 1.4  Dark green,red, etc available

2. Part List

3. Scope

 The scope of  this  specification  is to describe  the  construction  and  the  requirements  of  the  components  used  in  the access network where the micro duct is cut and needs to be blanked off.

3.1 Connector

The connectors shall have the necessary sealing arrangement to operate safely at blowing pressures of 18 Bar and protect the inner cavity against significant ingress of mud, sand and debris.  

3.2 Material

The  following  performance  tests will demonstrate satisfactory design performance and  material  selection  will ensure good lifetime and stability of performance characteristics. 

4. Testing

4.1 Operating testing

The Microduct Connectors shall with stand the following mechanical and environmental tests at ambient temperature of -10~30ºC,the pipe material is PE, PU or Nylon, the testing use the liquid or the clean compressed air after filtrating .

4.2 Burst Pressure Test

The  connectors  shall  be  sealed  well  at  internal  pressures  up  to  25  Bar  without  sustaining  damage,  or  permanent deformation,  and shall remain connected to the duct. Pressure shall be increased through to failure of the connector or duct. The pressure and mode of failure shall be recorded.  

5. Design Lifetime

The connector shall meet all performance requirements over a minimum period of 10 years at the normal condition.  

Exhibition: