Fast heating industrial cartridge heating tube for packing machinery

1.Introduction of Cartridge Heater Element

Cartridge Heating Element is a piece of equipment made of MgO powder or MgO tube, ceramic cap, resistance wire(NiCr20/80). It is used to heat in plastic injection moulds, dies, platens and so forth. 

2.Recommended for temperatures up to 750°C

 
All high temperature resistance cartridge heater are available with a built in Thermocouple Type J or K

3.Specification Requirements For Ordering

There are many leads options available, including Glass Fibre Leads, Silicon Rubber Leads, PTFE Leads, Ceramic Beaded Leads, Braided Leads and Conduits. Please advise us of the type of leads preferred. If you would like some assistance or advise on the correct lead to use, please do not hesitate to ask.

4.When Ordering high temperature resistance cartridge heater , please specify the following information :

1.Type of Cartridge Heater ( please refer to Termination Options ).

2.Tube diameter of cartridge heater.

3.Overlength of catridge heater.

4.Wattage & Voltage

5.Lead type ( glass fibre / PTFE ) & lead length.

5.Options uses for high temperature resistance cartridge heater .

1.Plastic Processing

2.Packaging Machinery

3.Injection and Blowing Moulding

4.Extruders

5.Foundries

6.For Fastening of turbine bolts

7.Soldering pots