water base cold laminating glue

A600

Water base cold compound special paper-plastic laminating adhesive include such models as AAA-80,AA600,A800,A600,A200,AB600,AB200,B400,B300,B150,C400,C300,C150,D400,D300,E400,E300,AA500,AA300 and so on.

Huacheng company's laminating adhesive production scale, technical level and market sale are at top position compared with other factories.

1,Technical indexes:

Type A600

Characteristics High solid content,suitable for low price,medium powder covering grade

and higher requirements.A600 is a little thinner than A800 with the same

other indexes. Having special adhesion to the coated papers which is the

best type for adhesion and can reach up to the highest level of bonding.

Appearance Milk white sticky liquid

PH value 5-7

Packing 50KG plastic barrel

Storage Six months at 0-50°C

2,Adhesive must be anticold and sun block. Avoid exposure to the sun in summer and keep in cold place, in particular above 0 °C in winter. If adhesive was freezing, don't heat up at once and should place it in room with a temperature above 5°C to make it melt slowly. If no layer separation phenomenon after melting, filter with 100 mesh screen. During storage and after use, seal it so as to avoid molding and skinning and shorten quality term.

2,Huacheng brand series laminating adhesive can't be mixed with other ones. Mustn't add other substances so as to produce chemical reaction. Of course include water.

3,Printing ink must be dry completely, then use this product.

4,Before use, clean roller on laminating machine. No adhesive skin and impurity.

5,Corona quantity on BOPP film treatment surface must be above 39 dyne. Common factories' BOPP film electric treatment surface is inside rolled film. Small BOPP film corona quantity results in unfirm adhesion and film removing.

6,Adhesive quantity depends on paper, ink and film. Observe whether there are snow-shaped bright spots on copy. If yes, it is because of three factors such as too small adhesive quantity, small pressure and more powder agent. Then add adhesive quantity, pressure adjusting and powder removing. At that time no bright spots, but after several minutes to dozens of hours, find chicken paw shaped, snow-shaped and flaw-shaped spots, commonly the reason is that adhesive and ink react each other. It is because of un-completely drying ink or more dry and adhesive.

7,In principle, after powder spraying on printing products' surface, rub powder before compound film. Directly operate if powder is small. Please choose lid powder special adhesive.

8,During roll exchanging, please don't keep downtime so long, so as to skinning.

9,Place it untile compound products is transparent not white and start cutting.

10,While new printing products compound film or exchange different adhesive, please sample and check before bales of production.

11,Please notice gold or silver printing products in particular. Sometime there is color changing phenomenon. Place it about one day and if color is not changing, then compound film. Meanwhile lengthen solidification time.

12,Please don't use strong alkali glue board making and tile hanging so as to in avoid from such phenomenon as molding and layer removing. Also note that glues such as sodium-silicate quantity is so large and react with glue through paper.