gas vent

In order to achieve its maximum molding productivity, simply using its ultra micro breathing cell to exhale gas and air from molds.

Key problems to be solved;
1. Burnt:
When aberration and burnt issues occurred for resin filling faster than air exhaling, it would result gas vent overheated.
2. Overflow
There are 2possible conditions:

. When temperature of resin gets higher at the tip seaming, it weakens its bonding strength.
. When temperaure of resin gets higher at the tip of seaming, it weakens its bonding strength.
. Air can fllled up the path and blocks resin to flow functionally which will cause ejection pressure to rise and materiais to overflow.

3. No enough fillings:
4. Cell Streak:
If there are some cells, streaks and mottles occurred, it is caused by the tact that the cells have not been vaporized completely between air and resin.
5. Extensive Cycling Time:
The higher temperature of resin, molds and slower speed of injection cause extensive cycling time, however, it will not affect the quality of final products.

Energy, Time, and Cost Saver:
1. It will reduce the trial die, time and materials if users consider to use TX gasvent the beginning of the design.
2. It will save up to 1/3 to 1/10 of the total cost and time if installing gas vent.

Installation:
1. Do not touch the surface when gas vent is in use.
2. Use H7/S6 from JIS reference chart.