overhead line fitting/armor rod/line splice

Specifications

1. ISO 9001:2008
2. Years Experiences
3. Direct Manufacturer
4. Long Life Time
nvenient installation

General information:

           Preformed Lineguards provide economical conductor protection at points of support (and taps) in urban type distribution systems where low working tensions and short conductor spans are common.
        Preformed Lineguards are intended to protect against abrasion, arc-over and may be used as patch rods designed to restore full conductivity and strength to conductors where damage is located outside the support area and does not exceed 25% of the outer strand layer.  Preformed Lineguards
are recommended as a minimum protection for hand-tied insulators.
       Both in initial installation cost and in long-term cost, Preformed Lineguards virtually eliminate the possibility of conductor mechanical failure at support points. 
       Preformed Lineguards may be used as tap armour to protect conductors from wear and flash-over damage under hot-line taps. .