Hot melt adhesive for manual edge banding

Specifications

Wide area of application, for bonding all kinds of edgebands to particleboard and MDF.

                                      

                     

Hot Melt Adhesive for edge-banding(low temperature, manual)

 

APPLICATION  Wide area of application, for bonding all kinds of edgebands to particleboard and MDF.

 

PROPERTIES   Good melting properties

                         No stringing

                         High green strength

                         Good thermal stability

                         Good wetting properties

TECHNICAL    Viscosity            12000-24000CPS@180°C

DATA               Soft Point           79-83º C

                         Appearance          Light granule(with several colors)

                         Solid Content         100%

CONDITION    RY9397 should be used on any type of semiautomatic and manual edge banding machine.

                         Coating can be made either on the edge or on the section material.

                         The coated material is immediately placed in contact with the substrate and pressed with rolls.

                         Application temperature:  130-150°C

                          (The temperature should be checked directly in the gluing system)

                        Coating weight:  50-100g/m2           (Depending on edges nature and substrate)

                        Coating speed:   10-25m/min

                       The supports and edges must be at ambient temperature(which should not be less than 15°C)

                       and the level of humidity should not exceed 10% in order to obtain a good bond.