FCP filter centrifugal low pressure Swimming pool pump Quality Choice

Specifications

swimming pool jet pump
1, 100% Copper wire and brass impeller
2, quiet running
3, energy saving
4.high quality

FCP2 Swimming Pool Pump

The working principle of the swimming pool water pumps and the completing device is as below:

8Both water and filth are sucked into the suction-disk;
8Then go into the pump to be roughly filthered to get rid of large grained dirts such as leaves;
8Then go into the filter tank through the transport flexible tube to be fine filtered;
8The clean water via filtering goes back to the pool, thus the filtering is finished.


This set of equipment has an advantage in the unnecessity to change the pool water, only periodically use it to clean and fillter and the operation becomes facilitied with the hand truck use. It is powerfully competitive in the world market due to its convenient movement and superior performance. It can also be used for the cold-hot circulation system of sauna.

 

 

 

 

 

 

Schematic diagram of working of the swimming pool pump:

 

1:Suction-disk   2:Long handle   3:Flexible tube   4:Water pump   5:Filter drum

 

STRUCTURAL SCHEMATIC DIAGRAM OF THE FILTER DRUM:

 

    

 

1:Handle	2:Pin	3:O Type sealing ring	4:Washer	5:Spring	6:Valve	7:Sealing ring
8:Valve	9:Sealing ring	10:Valve chest	11:Clamp loop	12:Sealing ring	13:Valve seat	14:Filter-net base
15:Water tank	16:Guide pipe	17:Filter-net lid	18:Basic block	19:Basic	20:M8X90 Bolt M8X90	21:Nut M8
22:Water-inlet pipe	23:Screw M6X25	24:Am6 Nut Am6	25:Bolt M6X55	26:Water-outlet pipe

SCHEMAATIC DIAGRAM OF OPERATION OF THE FILTER DRUM