ARTNET DMX Controller DC12V and DC24VDMX512 DeCoder addressable DMX Controller Quality Choice

Specifications

DC12V and DC24V addressable DMX Controller
1.Volt:DC12V and DC24V
2.Channel: 3
3.Output power:12V:<144W, 24V:<288w
4.RGB

DMX512 DeCoder addressable DMX Controller

 

Parameters:

Working temperature	-20-60°C
Supply voltage	12V~24V
0utput	3 channels
Connecting mode	common anode
External dimension	L164*W65*H40 mm
Packing size	L183*W82*H60 mm
Net weight	360g
Gross weight	410g
Output gray	RGB each 256 levels
Output current	<4A(each channel)
Output power	12V:<144W, 24V:<288W

 

 

Direction for use

This product is in compliance with DMX512 protocol, and compatible autoindex addressing and manual establishment address.

Each universal DMX controller takes up 3 DMX addresses. It adopts 2 ways (autoindex addressing and code switch) to set up the address. When adopting the autoindex addressing, all switches are “off” status. When adopting the code switch to set up address, the 10th bit(FUN) is “off” status, and other 9 bits are binary value code switch which are used to set up the DMX starting address code. The first bit is the lowest order bit, and the ninth is the highest order bit. That can set up 511 address codes. The DMX starting address code is equal to the sum of 1st to 9th bit. If move down one bit of code switch (“ON” set “1”), you can get the placevalue of this bit. If move up (set “0”), the placevalue is 0. For example: if you want to set up DMX starting address code for 73, you should move down the 7th, 4th, and 1st bit of code switch for “1”, and others for “0”, Then the placevalue’s sum of 1st to 9th bit is 64+8+1. That is to say, the DMX512 starting address code is 73.  

 

 

DMX input/output interface :