two component polyurethane adhesive for filter(manufacturer)

Usage:

1.The material must be full rocked after each to the plastic injection machine plastic injection so that the A material mixing evenly.

1.Everytime the plastic injection machine plastic injection A material must be full before the shaking in order to the   material until

2.AB material proportioning ratio of A:B=100:25 or 4:1.28°C,you can start operation

3.Material temperature controlled 24°C-28°C appropriate then you can start operation.

4. Must be clean before using the mould release agent (Note:

The new plastic mould can be wiped free)

5 .If A and B is not reaction please measuring A and B ratio.

6. A and B must be sealed to .To avoid the air and water vapor reaction, as a result affecting the effect of colloidal

Anping sanlian filtering equipment Co.,LTD

Http://cnfilteradhesive.en.china.cn 

Address:  Hebei Province Anping County, Hengshui City, Hebei Filter City

Welcome to the information obtained from the sample to facilitate you yo test the adhesive properties,to make the right purchasing decisions to save money