Pan mill Gold grinding machine

Specifications

1. Simple structure and high efficiency
2. Easy to operate
3.Low investment and energy consumption.
5. Polluation free

              Pan mill Gold grinding machine 

I.Introduction to pan mill

The wet pan mill gold grinding machine is a new mill, small investment, high yield, the production cost is low, good benefits.

The gold grinding machine is named by the diameter of roller. Φ1300,Φ 1350,Φ 1400,Φ 1500,Φ 1600 is suitable for selection of iron ore, molybdenum ore ,lead ore ,zinc ore, antimony ore and so on. Φ 850, Φ 900, Φ 1000,Φ 1100,Φ 1200 is suitable for selection of gold ore. 

As their small investment, high yield, the production cost is low, good benefits, praised by users, domestic alternative to the ball mill equipment. Grind gold machine easy installation and maintenance, small investment, high yield, quick, low-cost production, is the ideal equipment for mine SMEs beneficiation.

 

Mainly used with gold, silver, lead, zinc, iron, molybdenum, copper, antimony mine, mine, all ball mill can be selected grind gold machine can be used. Characteristics: grind gold through the raw material mixing, rolling, crushing, rolling repeatedly reach moisture equilibrium ratio of uniform, low gas content, improve the forming rate and forming quality, grind the material through the machine molding Products with high density, good strength, no porosity ratio weight. Energy efficient, high volume of output, the product is used for iron ore process tailings recovery, not to slag the loss of effective resources can be fully utilized

 

II.Grind Gold Machine Use and Maintenance

 

1.The normal operation of the mill, before they start feeding.

 

2, this machine prohibit strip start, the outage at boot time, you must first clean up the residual ore in the middle of the milled slot and then start.

 

3, should be uniform feeding not erratic, it is best to use the feeder.

 

Part

 

4, bearing frequent butter, gear box or car rear axle with frequent checks whether the loss of gear oil.

 

5, regular checks of the various parts of the screw is loose.

 

6.Found bearing damage must be promptly replaced, shaft eccentric avoid damage to other parts

 

7 mill runtime to pay attention to that the reducer or bearing part of the presence or absence of abnormal sound, whether the temperature is too high, the motor current is too large irregularities; should be shut down immediately if the above phenomenon, exclude.

 

8, machine maintenance, to ensure safety, you must remove the motor belt.

 

III. Technical Data

Model	Speed r/min	Power (kw)	Process ability( t/h)	Weight(T)
850	13-18	4.5	0.4	3
900	13-18	5.5	0.6	3.6
1000	13-18	5.5	0.8	4.2
1100	13-18	7.5	1	4.6
1200	16-18	7.5	2	5.8
1300	16-18	11	3	8
1350	16-18	13	4	8.5
1400	16-18	15	5	9.5
1500	20-22	22	8	10.5
1600	20-22	30	10	16

 

 Rollers for the gold grinding mill

Photo taken while delivering

 

Certificates we have