Modular Chiller and Heat Pump,with sroll compressor

Specifications

 The master module can work independently or together
with up to 7 slave modules, capacity from 76.6 to
612.8kW.
 Units with W type heat exchanger: panels, frame and
base are made from galvanized steel protected with
polyester powder painting to ensure total resistance to
atmospheric agents.
 3-phase scroll type compressor, with built-in thermal
overload cut-out and crankcase heater, mounted on
rubber vibration dampers.
 External rotor type axial fans, equipped with three
phase direct drive motors, low noise 8 poles, protection
level IP54, provided with a protective outlet grille.
 Evaporator built with high efficiency tube in tube type
heat exchanger, factory insulated with flexible close cell
material.
 Condenser built with seamless internal screw thread
copper tubes mechanically expanded into blue wave
hydrophilic aluminum fins.
 Refrigerant circuit complete with charge valves, filter
drier, sight glass, gas-liquid separator, thermostatic
expansion valve, high & low pressure switch. The heat
pump unit is completed also with 4-way valve, liquid
receiver and one way valve.
 Hydraulic circuit built with galvanized pipe, complete with
water discharge connection for tube in tube heat
exchanger and flange type hydraulic connectors in two
directions easy for connections from both sides of the
units.
 Electric panel consist of: Compressor contactor, fan motor
contactor, compressor protection breaker, fan protection
breaker, phase sequence relay and microprocessor with
function display (display only for master/packaged unit)
 Automatic operation dramatically reducing maintenance
cost thanks to reliable microprocessor system.
OPTIONAL
 Paddle flow switch;
 Metallic filter for hydraulic circuit;
 Water pump;
 Rubber antivibration mounting.