WINSUN 12V flame sensor module with 50cm long lead flame sensor detection

12V power supply stable version witH 50cm long lead flame sensor module

Use:
All kinds of flame, fire source detection, 1 way relay output, can be connected to the 220V large current equipment
Module features:

1, can detect flame or wavelength in the range of 760 nm to 1100 nm light source, lighter test flame distance is 80cm, the greater the flame, the farther the test distance

2, using the 12V power input eclusively for relay, onboard 78l05 regulator triode, provide sensor comparator, make the product more stable and reliable;
3, detection angle of 60 degrees or so, the flame spectrum is particularly sensitive
4, the sensitivity is adjustable (blue digital potentiometer adjustment)
5, the comparator output direct trigger relay
6, the size of the shape: 6019mm, thick 19mm, with a fied bolt hole, easy to install
1, 7 output with blue terminal block, wiring convenient
Electrical parameters:
Power supply voltage: 12VDC
Current: more than 200mA
Load: 10A 250V AC or 10A 30V DC

Module instruction:
1, flame sensor is the most sensitive to the flame, the sun is also a reaction to the general use of fire alarm and other purposes.
2, by adjusting the potentiometer, you can set the intensity of the flame sensors, when the flame eceeds a set threshold, relay, a public end and often start connected, when the flame is lower than the set threshold, relay disconnect, public ends with the normally closed terminal is connected;
3, the public side, normally open, normally closed three ports is equivalent to a double control switch, relay coil power, the public and often start conducting, without electricity, the public and the normally closed end;,
4, the sensor and the flame to maintain a certain distance, so as to avoid high temperature damage to the sensor, the flame of the test flame distance of 80cm, the greater the flame, the farther the test distance
Delivery list:
1 way 12V flame sensor plus relay module 1,Long lead wire with 50cmFlame sensorOne article.

1 sensors and relay module wiring diagram:

12V sensor plus relayMethod for controlling connection of alternating current:

The relay output terminal pin is stated as follows:

Relay module control AC equipment wiring diagram:

Relay module control DC equipment wiring diagram:

needBoCan open the following link to buy:

http:///item.htm?spm=2013.1.0.0.wIYz&id=19983664444&

Need a power line friend, please click the link below to buy:

/item.htm?spm=a1z10.1-c.w4004-5048412938.46.0cHl1p&id=16803581015