Band rf Optical Transceiver
Main Features
n Long transmission distance. According to different configurations, the transmission distance ranges from 10km to 300km; The optical fiber attenuation is extremely small, about 0.2~0.4dB/km
n Low power consumption. The power consumption of a pair of RF optical transceivers is only about 30W
n The optical cable is light and takes up little space. It is easy to install and maintain. One optical cable can have hundreds of fiber cores
n The optical fiber is not affected by electromagnetic radiation and lightning interference
n Excellent RF response flatness
n Extremely wide dynamic range
n The signal format is transparent and applicable to various signal encodings, communication standards, and network protocols
n Supports local control via buttons, and the LCD displays status and alarms
n Supports RS232 remote control interface (optional)
n Supports WDM optical wavelength output to enable the transmission of multiple optical signals over a single optical fiber, significantly reducing the leasing cost of optical fiber rental services (optional)
n Multiple structural forms: Standard 1U chassis, card-type, outdoor type, and modular type
Technical Specifications
n Frequency: 950 - 2150MHz
n Input/output VSWR: Less than 1.5:1
n Minimum signal level: -100dBm
n Dynamic range: Greater than 100dB
n Input/output 1dB compression point: +5dBm
n Noise figure: Less than 15dB
n Link gain: 0
n In-band ripple: ±1.0dB
Optical Transmitter
n Operating wavelength: 1310nm±20nm, single mode. (1550nm/DWDM wavelength is optional)
n Output optical power: >0dBm (Other values are optional, 14dBm)
n Side mode suppression ratio: >30dB
n Optical reflection loss:
n Fiber optic connector: FC/APC
n RF connector: SMA, 50Ω
n Power consumption of optical transmitter:
n Transmitter structure: 1U, 19-inch standard chassis, color is gray-black, surface treatment is powder coating, depth
Optical Receiver
n Operating wavelength: 1290nm~1610nm, single mode
n Receiving sensitivity:
n Optical reflection loss:
n Fiber optic connector: FC/APC
n RF connector: SMA, 50Ω
n Power consumption of optical receiver:
n Structure: 1U, 19-inch standard chassis, color is gray-black, surface treatment is powder coating, depth
Environmental Parameters
n Operating temperature: -30~+60℃ (outdoor), 0~+45℃ (indoor)
n Storage temperature: -40~+85℃
n Relative humidity: 10%-95% (25℃)
n Power supply: AC 220V±10%, 50-60Hz, IEC-320 standard three-core socket
Application Fields
n Remote optical transmission of antenna signals
n Long-distance radio frequency fiber optic communication
n Mobile communication LTE-4G/5G, GSM/CDMA/TD-SCDMA/WCDMA
n Military three-wave communication
n Remote control and telemetry, data link
n High-speed optical wave characteristic measurement
n Delay line
Send Inquiry to This Supplier
You May Also Like
-
1x2 Cwdm Coarse Wavelength Division MultiplexerNegotiableMOQ: 0 Piece
-
rf Optical TransceiverNegotiableMOQ: 0 Piece
-
Sfp Gigabit Optical Module, Domestic Optical Module, Independently Developed Optical ModuleUS$ 3.85MOQ: 1 Piece
-
10g Optical Module Sfp+ 1310nm 220m 10 Gigabit Optical Module 10g All-domestic Optical ModuleUS$ 3.08MOQ: 1 Piece
-
100g Optical Module Qsfp28-lr4 1310nm 10km 100% Domestic Optical ModuleUS$ 7.69MOQ: 1 Piece
-
Special Optical Modules, 10g Usot Parallel Optical Module Series, All-domestic Optical ModulesNegotiableMOQ: 0 Piece
-
50g Optical Module Sfp56 er 1310nm 40km 50g Fully Domestic Optical ModuleUS$ 11.54MOQ: 1 Piece
-
FCM100E P0972ZA Foxboro Fcm100e (p0972za) Fiber Communication ModuleNegotiableMOQ: 1 Piece
-
8 Layers, 3rd Order HDI High-frequency Mixed Pressure Buried Copper PCB,8th Layer 3rd Order Optical Module Buried Resistance PCBNegotiableMOQ: 20 Units
-
Optical Module Good Product SFPUS$ 8 - 88MOQ: 50 Pieces