Rubber Track Assembly Modified for Loader With Flexible Steering

Improper driving operation is the main factor causing damage to rubber track chassis. Therefore, in order to protect the rubber tracks and extend their service life, users are advised to pay attention to the following matters when using the machine:

(1) Overloaded walking is prohibited. Overloaded walking will increase the tension of the rubber track, accelerate the wear of the core iron, and in severe cases, cause the core iron to break and the steel cord to break.

(2) Do not make sharp turns while walking. Sharp turns can easily cause wheel detachment and damage to the track, and can also cause the guide wheel or anti detachment guide rail to collide with the core iron, causing it to detach.

(3) It is forbidden to climb steps forcefully, as this can cause cracks at the base of the pattern and, in severe cases, break the steel cord.

(4) It is forbidden to rub and walk on the edge of the steps, otherwise it will cause interference between the track edge and the body after rolling away, resulting in scratches and cuts on the track edge.

(5) It is prohibited to walk over bridges, which is one of the main reasons for pattern damage and core iron breakage.

(6) It is forbidden to walk on sloping roads, as this may cause the tracks to slip off and cause damage.

(7) Regularly check the wear status of the drive wheel, guide wheel, and support wheel. Severely worn drive wheels can cause the core iron to be hooked out, leading to abnormal wear of the core iron. Such drive wheels should be replaced immediately.

(8) Rubber tracks need to be regularly maintained and cleaned after use in environments with excessive sediment and flying air. Otherwise, it will accelerate the wear and corrosion of rubber tracks.

Overall, as long as users pay attention to the above matters during use, the track life will be correspondingly extended.